Massachusetts Hoisting Training Questions and Answers 100% Solved

Massachusetts Hoisting Training Questions and Answers 100% Solved What regulation controls Hoisting Machinery operation, licensing, and temporary permitting? Hoisting Machinery operation, licensing and temporary permitting is controlled by 520 CMR 6.00 What activities are covered under the hoisting regulations ? The regulations, appearing in 520 CMR 6.0.0, apply to any Hoisting Machinery that has the minimum capability of Hoisting the load higher than 10 feet or that has the capability of lifting loads greater than 500 pounds or if the capacity of the bucket exceeds 1/4 cubic yards capacity. Who must have a Hoisting operators license? M.G.L. C 146 £ 53 states including but not limited to excavators, backhoes, front end loaders, uniloaders, skid loaders, skid steer loaders, compact loaders, or similar devices, lattice cranes, derricks, cranes with or without wire rope; all fork lifts, powered industrial lift trucks, overhead hoists (underhung), overhead cranes, underhung cranes, monorail cranes, lifting devices, cableways, and powered platforms, must hold a Hoisting Operators license Can you renew license on web site? No, not at this time How old do you have to be to obtain a Hoisting License ? Must be 18 years or older What must I do to get licensed as a Hoisting Operator? 1. Must possess a valid and current drivers license to operate Hoisting Machinery 2. Complete and send the Department the following: A. Complete application B. Copy of drivers license C. One 2X2" photo of yourself D. Copy of D.O.T. Medical Card E. Check or Money Order for $75.00 F. Pass exam What is the purpose of the swing gear on an excavator? It connects the car body to the tracks Who is responsible for inspecting a trench before anyone goes in it ? The Equipment Operator What is the preferred sling angle of these angles 60 degrees The top of the spoil pile is called the _______________? Crown A four-foot (4') deep trench requires an additional ladder for every ___________ feet of open trench 25 Feet Materials must be kept back from the edge of the trench a minimum of ___________? TWO Feet When can an inspector revoke a hoisting license? Failure to pay excise tax Who developed the MA Crane Hand Signals ? ANSI/ASME DOT stands for ? Department of Transportation When do you do your walk-around of the equipment?