Massachusetts 1C Hoisting License Questions with Verified Solutions

Massachusetts 1C Hoisting License Questions with Verified Solutions What equipment falls under a 1C license? Hydraulic telescoping booms without wire ropes and forklifts Definition of a forklift Any mobile powered-propelled truck used to carry, push, lift, pull, stack or tier materials. Types of forklifts Moving mast, fixed mast with telescoping reach, telescoping boom with areal reach. Off-road type of forklift Lull Where should manuals be kept? On the machine at all times Danger signal word indicates Hazardous situation that WILL result in death or serious injury Warning signal word indicates Hazardous situation that COULD result in death or serious injury Caution signal word indicates Hazardous situation COULD result in MINOR or MODERATE injury Notice signal word indicates Addresses practices not related to physical injury. When should equipment be inspected? Prior to each use Equipment can be modified from its original configuration Never Lifting a load over someone is permitted Never Wearing a seat-belt is required Always, if a Roll Over Protective Structure is installed Attachments must be Approved by the manufacturer Free-rigging or suspending a load can only be done With approval from the manufacturer Loads should be carried As low as possible Riders can be allowed Never Shutdown procedures include Lowering the forks to the ground, setting the break, shutting off the engine, cycling the control levers, and removing the key. Load charts Must be displayed clearly on the machine at all times. How should you proceed around blind corners? Stop before turning, sound horn and proceed slowly. Control configuration for starting Set breaks, controls neutral. If a condition causes loss of control, what should be done? Stop motion and shut down machine in place. Apply a DO NOT OPERATE tag. When is a slow moving vehicle placard required? When traveling on a public road. To mount and dismount Maintain a 3-point contact with machine. Either two hands and one foot or two feet and one hand. Never use for points of contact when mounting/dismounting Controls, steering wheel, petals Passing under a lifted boom is okay. Never When driving, the operator should look In the direction of travel If someone approaches the machine Stop immediately. No person should enter this area when the machine is operating Operating radius of the forklift Before lifting the operator should know what about the machine? The rated load capacity Before lifting the operator should know or estimate what two things about the load? The weight and load center What should the operator refer to determine the operating range Capacity chart of the machine If traveling over soft or unstable