Nyc real estate 18 EXAM with 100% correct answers already graded A+ 2024

That part of the foundation which transmits loads directly to the soil is called the footing. The purpose of the footing is to spread the load over a greater area to prevent or reduce settling. The footing holds the entire weight of the building. The foundation wall sits on top of the footing and is usually about 8 inches wide and made of poured concrete or concrete blocks. If the area between the foundation walls has been excavated deeply enough to provide head room, then a basement has been created Generally, batt insulation is the least expensive wall insulation material but requires careful installation for effective performance. What site requirements are regulated by New York State? New York regulates wells and sanitary waste systems. What does a footing do? Supports the entire weight of a structure. What is a sill plate and what does it do? A sill plate is a wooden support member that is laid on top of and bolted to the foundation wall. This sill plate serves as the base for the wall framing. What are the three types of frame construction? Platform Balloon Post and Beam Copper wiring does not overheat and it can carry both large and small loads. Most new buildings have copper wire throughout, except at the service entrance where aluminum is still used. Romex is a brand name for a type of plastic insulated wire, sometimes called non-metallic sheath. The formal name is NM. This cable is suitable for use in dry, protected areas that are not subject to mechanical damage or excessive heat. Most new homes are wired almost exclusively with NM wire. New York business law states that any home improvement contractor who enters into a contract for more than $5,000 must deposit any payments he or she receives into an escrow account until the project is completed. What is the most common type of heating system in North America and how does it work? A forced-air heating system is the most common. It draws room air through ductwork and a filter into a furnace, where the air is heated. The warmed air is then blown back to rooms through ductwork. What are the two types of heat pumps available? Air source and ground source Name three types of pipes used in plumbing systems. (See screen 33 for other correct answers.) Cast iron Copper PVC What is the difference between voltage and amperage? Voltage is a measure of how much pressure the electrons in a circuit are under. Amperage is a measure of the amount of electrons moving through the circuit. Studs used to frame the roofing system are called rafters. What forms the bed for a structure's foundation? Ground Which type of building is exempt from the current New York energy code? Historical Oil-fired heating has what disadvantage? Requires delivery and storage Which of the following documents is NOT filed with the planning board prior to construction beginning? Building permit Contractors must obtain building permits before they can start construction, so they file blueprints, specifications, property surveys, deeds, and any approved applications for plumbing and electrical work to obtain the permit from the planning board. Who provides guidelines for the construction of private wells in New York? The New York State Department of Health What type of furnace has a heat exchanger to burn the fuel, which is either natural gas, propane, or butane? A gas-fired furnace What onsite system is designed to treat and dispose of domestic sewage? A septic system What does the New York Uniform Fire Prevention and Building Code require regarding vapor barriers that the National Building Code does not require? The barrier must be treated for termites. __________ insulation is a two-part liquid containing a polymer and a foaming agent. Spray foam Which of these types of wire would probably not be found in a residence? Steel wire