CCNA practice test questions with correct answers

What are the steps to configure a static route CORRECT ANSWER Configure unidirectional static routes to and from a stub network Define a path to the IP destination network Question: Which of the following commands will display information about the specific port channel interface? CORRECT ANSWER show etherchannel port-channel show etherchannel port-channel CORRECT ANSWER Use the [show vlan] command to verify that the port is in the correct VLAN Use the [show mac address-table] command to check which addresses were learned on a particular port and which VLAN that port is assigned You are troubleshooting a connectivity issue on the Branch router when you realize that a ping test to the destination network is not successful. The Branch and corresponding HQ router have their neighbor adjacency set up. What could be the problem? CORRECT ANSWER The HQ router isn't advertising the route There is a route missing to the destination in the Branch router`s routing table A user is experiencing a loss of end-to-end connectivity in an IPv4 network. You have verified that there is no physical connectivity issue. Logically, what should you check next? CORRECT ANSWER Whether the current path is undesirable Which statements describe a trunk operation? CORRECT ANSWER It's the link between an Ethernet switch interface and a router Cisco supports the 802.1 Q trunking protocol