Plumbing Journeyman Exam Questions and Answers 100% Solved

Plumbing Journeyman Exam Questions and Answers 100% Solved True (IPC 425.4) - answerA 4-inch by 3-inch closet bend shall be acceptable. T/F 10 (IPC 403.1) - answerWhat is the minimum number of toilets in an educational facility men's room if the facility enrolls 500 people? accessable - answer"Drinking fountains shall be located on a/an ____________ route." 2" (IPC 406.2) - answerWhat is the minimum waste connection for an automatic clothes washer? 30", 56" (IPC 405.3.1) - answerWater closet compartments shall be not less than _____ inches in width and _____ inches in depth for wall-hung water closets. approved (IPC 402.1) - answerPlumbing fixtures shall be constructed of _______________ materials. 12", 60" (IPC 405.3.5) - answerThe walls or partitions shall begin at a height not greater than _____ inches from and extend not less than _____ inches above the finished floor surface. False, 120 degrees (IPC 412.5) - answerThe hot water supplied to bathtubs and whirlpool bathtubs shall be limited to not greater than 110°F. T/F 30", 60" (IPC 405.3.1) - answerWater closet compartments shall be not less than _____ inches in width and not less than _____ inches in depth for floor-mounted water closets. 1/4" (IPC 421.3) - answerRemovable shower strainers openings shall not be less than _______ inches in least dimension. 1 1/4" (IPC 419.3) - answerWhat is the minimum waste connection for a lavatory? 2' (IPC 413.3) - answerWhat is the minimum waste connection for a floor drain? True (IPC 405.4) - answerThe (toilet) flange shall be attached to the drain and anchored to the structure. T/F 30 (IPC 405.3.5) - answerThe horizontal dimension between walls or partitions at each urinal shall be not less than _____ inches. prohibited - answerAny water closet that permits siphonage of the contents of the bowl back into the tank shall be __________. Trough urinals shall be __________. T/F two (IPC 403.1.3) - answerWhere _________ or more toilet rooms are provided for each sex, the required number oflavatories shall be distributed proportionately to the required number of water closets. False. 120 degrees (IPC 412.10) - answerHead shampoo sink faucets shall be supplied with hot water that is limited to not more than 110°F (49°C) by a water-temperature-limiting device. T/F 1 1/2" (IPC 407.2) - answerWhat is the minimum waste connection for a bathtub? 3" (IPC 413.4) - answerIn public coin-operated laundries . . . drains shall have an outlet of not less than _____ inches in diameter. True (IPC 403.1.1) - answerTo determine the occupant load of each sex, the total occupant load shall be divided in half. T/F 405.6 - answerWhich code section states that "Joints formed where fixtures come in contact with walls or floors shall be sealed." ? 22 (IPC 421.4.2) - answerThe shower compartment access and egress opening shall have a clear and unobstructed finished width of not less than _____ inches. 1 1/2" (IPC 422.2) - answerWhat is the minimum waste connection for a sink? 500 (IPC 403.3.3) - answerIn public and employee toilet facilities, the path of travel to such facilities shall not exceed a distance of _______ feet. 3" (IPC 421.3) - answerRemovable shower strainers shall not be less than _______ inches in diameter. Trap seal, Trap outlet, Trap inlet (IPC 405.9) - answerWhich three locations are slip joint connections allowed? None required (IPC 411.2) - answerWhat is the minimum waste connection for an eye wash station? False (IPC 403.1) - answerThe occupant load for seasonal outdoor seating and entertainment areas shall not be included when determining the minimum number of facilities required. T/F False (IPC 403.3.6) - answerWhere a toilet room is provided for the use of multiple occupants, the egress door for the room shall be lockable from the inside of the room. T/F True (IPC 425.2) - answerWater closet