EPA 608 Type III Exam Correct Questions & Answers(Latest Update ) Before recovering refrigerant from a chiller suspected of having tube leaks,... - ANSWER

Before recovering refrigerant from a chiller suspected of having tube leaks,... - ANSWER ...drain the water sides of the evaporator and condenser. Draining the water sides helps to avoid the introduction of additional water into the system cause by the evacuation process and to prevent the water from freezing as the refrigerant evaporates during recovery. How can you pressurize a low-pressure chiller to make a non-major repair? - ANSWER Warm up the system. Under EPA regulations, you may warm up the refrigerant to pressurize a low-pressure chiller for the purpose of opening the system for a non-major repair. When does the EPA allow you to NOT evacuate to the prescribed level? - ANSWER When leaks in the appliance make evacuation to the prescribed level unattainable. EPA requirements require low-pressure systems to be evacuated to... - ANSWER ...28.9 inches Hg (25 mmHg Absolute, 25,000 microns) unless such evacuation would introduce air into the recovery system because the system has a leak. An industrial process refrigeration system containing 600 pounds of has a substantial leak that is leaking at a rate above the leak rate threshold. Unless granted additional time, what must be completed within 30 days? - ANSWER Repair the appliance so that it leaks below the threshold and conduct the initial verification test. A purge unit is connected to the... - ANSWER ...top of the condenser.