NEIEP 500 Final Exam Questions With Answers Updated 2024/2025 (VERIFIED A+)

NEIEP 500 Final Exam Questions With Answers Updated 2024/2025 (VERIFIED A+) What device is installed to hold the vertically biparting freight doors mechanically closed? (Ans- Keeper Which of the following statements is correct regarding single-section swing doors used as emergency exits for blind hoist ways? (Ans- The doors must be self-closing and self-locking, a unique key, and switch to prevent elevator operations when open. When setting up a retiring cam for a freight elevator, which of the following statements is correct? (Ans- The cam must apply a force that is double what's required for normal interlock operation Refer to Figure 1: What contact or contacts are closed when the doors are closing and you have reached the first slow down? (Ans- 1 only NEIEP 500 Final Exam Questions & Answers Updated 2024/2025 (GRADED A+) What does the symbol shown below represent? (Ans- Ground How many turns of safety rope must remain on the safety drum after a rated load and rated speed test of a winding drum operated safely? (Ans- 3 What is the maximum force allowed during the passenger door closing cycle to prevent a door at rest from closing? (Ans- 30 lbs Proper adjustment of which of the following can reduce the effects of building compression on an elevator installation? (Ans- Rail jack bolts When installing passenger hoist way entrances in a rise of more than three floors without a running platform, which procedure should you follow? (Ans- Build a template that you can use to measure off the door frame locations and sill center line What type of flex would be used to pipe a switch in a wet location? (Ans- Liquid tight Flex Which of the following components is used to engage and couple the car door to the hoist way door during opening and closing? (Ans- Door clutch On high rise runs of raceway, the wires must be supported at least how many feet apart? (Ans- 100 feet If there is voltage at the generator armature, but not at the motor armature, what is most likely wrong? (Ans- The loop circuit is open You need to store a shipment of passenger hoist way doors. Which of the following statements are correct? (Ans- Store the doors vertically on the long edge What is the minimum size wire allowed by code for wiring 110VAC lighting circuits to elevator cars? (Ans- #14 Which of the following statements is correct for dumbwaiter installations that use mechanical locks and electrical contacts? (Ans- They are unlocked by a stationary cam located on the car When adjusting center-opening horizontal sliding passenger doors, what is the maximum the leading metal edges can be apart when the doors are closed? (Ans- 1/2" What is the minimum height of a barricade in place around an open well way? (Ans- 42" When bending conduit, what is the maximum number of bends in degrees between access points? (Ans- 360 degrees You are installing push button boxes in a high-rise building. What is the maximum height that they can be located from the floor level to the center of the fixture? (Ans- 42" Which of the following is a requirement that must be met when interlocks are installed on freight elevators? (Ans- It must be tamper resistant to prevent override of the door contacts What is the requirement for hoist way access switches for dumbwaiters? (Ans- They are required at the terminal landings when the rise is 25ft or greater