NEIEP 200 Final Exam Questions With Answers Latest Updated 2024/2025 (100% VERIFIED)

NEIEP 200 Final Exam Questions With Answers Latest Updated 2024/2025 (100% VERIFIED) you are using a plumb line to check a rail for plumb. you find that at the top it measures 1" and at the bottom it measures 1 1/4". what does this tell you? (Ansa. the top of the rail needs to go towards the center b. the top of the rail needs to go toward the wall c. the bottom of the rail needs to go toward the wall you are plumbing rails on a high rise installation. what type of plumb line should you use? (Ansa. nylon string b. monofilament wire c. piano wire you need to cut into a concrete wall. which tool should you use? (Ans- disc grinder with a diamond blade disc you need to select a heavy duty drill for drilling 5/8" holes in a machine beam. what factor determines the drill rating? (Ans- chuck size NEIEP 200 Final Exam Questions & Answers Latest Updated 2024/2025 (100% VERIFIED) you are tasked with setting 3/4" concrete anchors. which type of drill should you use? (Ans- rotary hammer you need to cut and 8ft section of 1/2" EMT conduit pipe. what would be the best tool for the job? (Ans- hacksaw with 24 teeth per inch you are directed to move oxy-acetylene cylinders from a storage area to a work site. what is the proper way to transport them? (Ans- in an upright position you are setting up welding equipment. what is the maximum psi that the regulator for the acetylene gas may be adjusted to? (Ans- 10-12 psi you are using rollers to move a heavy elevator machine and are approaching a corner. which technique should you use to maneuver around it? (Ans- angle front roller gradually and continue around the corner you are preparing to unload a truck at the loading dock and the truck is 8" higher than the dock. what do you do? (Ans- use a steel plate to span the gap you just finished the surface inspection of a manila rope you will be using for hoisting. what method should you use to conduct an internal inspection? (Ans- slightly untwist the strands you are preparing to hoist rails and are inspecting your manila rope. which of the following is a good characteristic of manila rope? (Ans- a light yellow color with a silvery or pearly luster a mechanic attaches a chain fall to a hoisting beam with a beam clamp. what happens to the capacity of the hoisting beam? (Ans- it is reduced to 50% of original capacity you are rigging elevator equipment with a sling angle of 60 degrees. you are using a shouldered eye bolt with a tapped 1/2" diameter hole. once the shoulder is seated, what is the minimum thread depth required? (Ans- at least 3/4" you will be hoisting 1klbs with a single leg vertical hitch. what will the sling load be when the load is in the air (Ans- 1k lbs you must attach a wire rope to a load by creating a loop with 3 u-bolt wire rope clips. how should the clips be attached? (Ans- no nuts on a dead horse you are using a bowline knot- what is one disadvantage of this knot (Ans- is can easily loosen when not loaded you are preparing to lift a load and need to tie the ends of two ropes together. which knot should you use? (Ans- square the rated load tag on a sling is 2000lbs. what does this mean? (Ans- load limit that can be picked and held you need to lift rails to the top floor of a building. with a well wheel at the top of the hoist way, what type of rope should you use? (Ans- synthetic a crane is needed to hoist controllers on to the roof. who is responsible for making the lift plan? (Ans- lift director during elevator install you need to rig equipment to the top of the building. what info must be included in the lift plan? (Ans- capacity of rigging material the crane operator is awaiting you signals to lift a pallet of parts. what are the correct audible signals to raise the load 20 feet? (Ans- hoist, hoist up, 20,15,10,1, hoist stop you are storing fiber core wire rope slings. what could cause damage to the core material? (Ans- solvents you are selecting a wire rope sling to rig 1000lbs. what safety factor does asme require? (Ans- 5:1 there could be unapparent wear in the slings you must use for hoisting. what sling rating take this into account? (Ans- rated load where is the best place to store natural fiber hoisting rope (Ans- open sided crate you have installed a power winch at the first floor preparing to hoist equipment. the hoist rope passes over a single sheave on the hoist beam making a direct pick. what is the downward force that a 3000lb load will exert on the overhead hoist beam?