Gas Technician G2 License Questions and Answers Already Passed

Gas Technician G2 License Questions and Answers Already Passed An inline Ammeter is connected In series with the device being checked As the length of an Electrical run increases, it may be necessary to Increase the Wire Size Fuses serving motor circuits should be of Time Delay Type Millivolt wiring should be isolated from Line Voltage Wiring because The Line Voltage will induce a voltage into the Millivolt Wiring Which tool is used to determine if the windings on an Electric Motor have shorted? Ohmmeter On an Electrical Schematic Diagram, the safety controls are typically drawn: To the Left of the Loads Which of the following types of wire must be used in Damp locations? NMW On an Electrical Schematic, all operating controls are drawn: Normally Open As the length of a Conductor Increases, the Voltage Drop along the Conductor: Increases When a new appliance is to be installed in a typical residential basement and the Supply Wiring to it is concealed, which of the following types of wire is acceptable, and most cost effective NMD When checking a circuit of unknown Voltage using an analog meter with 0-30V, 0-125V, 0-250V, and 0-600V, which scale should be selected 0-600V A 120 Volt Power Supply for a residential Electrical Circuit is taken from the: Load side of one branch circuit breaker and a Neutral Plug A receptacle mounted Ground Fault Circuit Interrupted protects against: Current Flow to Ground An Electrical Pictorial Diagram is used to: Show component location When using an Ohmmeter, the most important thing to remember is to: De-engerize the Circuit A zero Ohmmeter reading taken between the casing of a Solenoid and a disconnected Wire to the Solenoid indicates that The coil is shorted to the casing of the device The instrument used to determine Potential Difference in an Electrical Circuit is the: Voltmeter When the Voltage has been determine to be approximately 120 volts, which scale on an analog meter should be selected for most accuracy? 0-250 Volts The resistance of a Thermistor... as its temperature rises Decreases A