Module 9: Welding Inspection and Testing Principles Questions With 100% Correct Answers.

List type of weld joints - Butt, Tee, Corner, Lap. Fillet-is not a joint it is a type of weld The portion of the joint where the two pieces to be joined come closest together is called the - Joint Root A weld produced by filling an elongated hole in an overlapping member, fusing it to the member beneath is called a - Slot weld A weld having a triangular cross sections which is applied to a T-joint, corner joint or lap joint is called a - Fillet A weld used to build up thin surfaces and to provide a layer of corrosion protection and/or abrasionresistance is a(n) - Surfacing Weld The height of a weld above the base metal in a groove weld is the - weld reinforcement A(n)__________ fillet weld has the same leg and size dimensions. - Equal leg A weld formed by progressing along the joint with a side-to-side motion is called a - Weave bead The base material next to the weld that is not melted, but that undergoes structural and metallurgical - Heat Affected Area The problem occurring in weldments due to the non-uniform heating produced by welding is called - Distortion The most common type of destructive testing of welds is called - Bend testingAccording to the AWS D1.1 code, if a welder continues to use a particular procedure, how long does his/her qualification remain in effect? - Indefinitely -unless the ability of the welder is questioned A weld discontinuity caused by the improper termination of the welding arc is referred to as - Crater Crack A discontinuity that results from the entrapment of gas within the weld is referred to as - Porosity Which weld metal discontinuity is generally considered to be the most severe? -Crack