Exam (elaborations)
FAA General Fluid Lines and Fittings questions with correct answers
Rating
Sold
-
Pages
5
Grade
A+
Uploaded on
18-10-2023
Written in
2023/2024
Which coupling nut should be selected for use with 1/2 inch aluminum oil lines which are to be assembled using flared tube ends and standard AN nuts, sleeves, and fittings? CORRECT ANSWER AN-818-8 Metal tubing fluid lines are sized by wall thickness and... CORRECT ANSWER outside diameter in 1/16 inch increments. Proper order to make a single flare on a piece of tubing: CORRECT ANSWER 1) Slip the fitting nut and sleeve on the tube. 2) Place the tube in the proper size hole in the flaring block. 3) Center the plunger or flaring pin over the tube. 4) Project the end of the tube slightly from the top of the flaring took, about the thickness of a dime. 5) Tighten the clamp bar securely to p
Show more
Read less
Institution
FAA General Fluid Lines And Fittings
Course
FAA General Fluid Lines and Fittings
Whoops! We can’t load your doc right now. Try again or contact support.
Written for
- Institution
- FAA General Fluid Lines and Fittings
- Course
- FAA General Fluid Lines and Fittings
Document information
- Uploaded on
- October 18, 2023
- Number of pages
- 5
- Written in
- 2023/2024
- Type
- Exam (elaborations)
- Contains
- Questions & answers
Subjects
-
faa general fluid lines and fittings questions wit
$15.49
Get access to the full document:
Wrong document? Swap it for free
Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF
Also available in package deal
Package deal
FAA. Federal Aviation Administration|Tests Bundle Set
29
2023
$ 41.49
More info
