Dell Tech Certification questions and answers verified and updated 100% guaranteed success.

Dell Tech Certification questions and answers verified and updated 100% guaranteed success. If the system is not booting into the operating system, how can you check if the hard drive is detected? - The HDD indicator light or LED - From within the Windows (or other) operating system - Go to BIOS - Open the Chassis and Check - correct answers.Right answer: - Go to BIOS What does Factory Data Reset do on Dell Venue Tablet? - Will erase all personal data and downloaded applications on the Tablet - Resets the hardware, personal data and applications are not affected -Will allow you to restore the Tablet to an earlier date -Erases only personal data, all downloaded applications will remain intact - correct answers.Correct answer: - Will erase all personal data and downloaded applications on the Tablet State True or False: Discrete Graphics cards connect to the motherboard of a computer system using a slot, typically an Accelerated Graphics Port (AGP) or a Peripheral Component Interconnect Express (PCIe) - correct answers.Statement is: - True Why sometimes the values in BIOS cannot be saved and shows as manufacturing mode? - The systemboard jumper is at CMOS_CLR state - The systemboard jumper is at SERVICE_MODE state - The systemboard is faulty - THe systemboard jumper is at PASSWORD-CLR state - correct answers.Correct Answer: - The systemboard jumper is at SERVICE_MODE state Choose all that Apply: Which of the following statements are true about the New PSU BIST? - During PSU BIST, If PSU LED light will stay ON - PSU is functioning properly - To restart the PSU BIST : Disconnect the AC power cord for 15 seconds (PSU BIST reset time), and then plug in the AC power cord - To start the PSU BIST: Plug in the AC power cord & note the LED light status - Ensure to disconnect the AC power cord from the PSU, before starting the PSU BIST - correct answers.Correct Answers: - To restart the PSU BIST: Disconnect the AC power cord for 15 seconds (PSU BIST reset time), and then plug in the AC power cord - To start the PSU BIST: Plug in the AC power cord & note the LED light status - Ensure to disconnect the AC power cord from the PSU, before starting the PSU BIST How to initiate RTC reset? - Connect System to an AC Power => Power ON system => Press F12 for Boot Menu => Select Diagnostics