NACE CIP 1 CBT 2023 Exam | Questions with Verified Answers (Newly Updated 2023)

NACE CIP 1 CBT 2023 Exam | Questions with Verified Answers (Newly Updated 2023) Q: When reporting the wet film thickness from a wet film thickness comb/gauge (WFT) you report? Answer: The last tooth that has coating on it. Q: Adding an incorrect solvent to a coating may cause? Answer: Non drying and non curing. Q: You are reviewing the documentation for a tank waiting project and notice there is a conflict between the project specification and the manufacture's product data sheet on the required DFT of the primer. The owner is not reachable for clarification. What should be done? Answer: Follow the specification. Q: You know that you are sensitive to amines, but not polyamides. What document would you review prior to arriving on the joist to know whether amines will be used? Answer: The contractor's contract. Q: The formation of small bowl shaped depressions in the coating find cause by air trapped in the coating is called? Answer: Cratering Q: Failure of a plural component to cure is frequently caused by? Answer: Wrong mix ratio(metering) Q: One of the most common cause of clusters in a coating film is? Answer: Surface Contamination Q: You have been inspecting a tank repainting project and suspect the surface was not cleaned properly, but the coating has already been applied. What should you do? Answer: Consult owner for guidance. Q: After a cold night, you find that the epoxy amine midcoast applied the day before has blushed. The optimum (best) resolution when amine blush is found is to? Answer: Consult the coating manufacture. Q: As in Inspector on a bride painting project, prior to abrasive blasting,which blasting safety items would you expect to see? Answer: Deadman valve, Connections wired/clipped and Supplied air hood. Q: According to NACE SP0188, the wetted sponge is moved at a maximum rate of? Answer: 1 linear foot per second (30cm) Q: You are on a coating project and notice blisters in a variety of sizes and irregular shapes. What standard would you use to evaluate the blisters? Answer: ASTM D714 Q: When are NACE International surface preparation standards considered binding? Answer: When specified in the contract documents. Q: You are performing holiday testing early morning with dew on the pipe. The reason you may get erroneous indications is cause by? Answer: Telegraphing Q: Which joint NACE/SSPC abrasive blasting standard states that "Random staying shall be limited to no more than 33% of each unit surface area"? Answer: NACE No. 3/SSPC SP 6 Commercial Blast Cleaning Q: Which blasting standard allows for traces of tightly adherent mill scale, rust and highly adherent thin coating to 10%? Answer: NACE No. 8/ SSPC SP 14 Q: You have a 10mil (254 micron) conductive coating on a nonconductive surface and need to check for holidays and discontinuities. How would you perform the inspection?