CMIT 351 - University of Maryland_: Part 1: Design the Local Area Network, Part 2: Create the basic switch configurations, Part 3: Define the VLANs and Part 4: Implement VLAN Trunking

CMIT 351 - University of Maryland_: Part 1: Design the Local Area Network, Part 2: Create the basic switch configurations, Part 3: Define the VLANs and Part 4: Implement VLAN Trunking Part 1: Desi gn the Local Area Network Part 2: Create the basic switch configurations 2.1 Cable the network Describe in a few sentences which devices connect to which other devices using what specific kind of cable, on which specific interfaces? For example: I connect an Ethernet cable on port 1 on device A to port 1 on device B. 2.2. Configure the basic switch functions Describe the basic switch configuration here as if you are entering the commands into the devices. For example: I add an enable password using enable password p@ssw0rd 2.3 Configure the computers Describe the configuration you enter into each computer. For example: I add an ip address of 192.168.1.2 with a subnet mask of 255.255.255.0 and gateway of 192.168.1.1 to the wired Ethernet interface. 2.4 Test and Validate Connectivity Describe how you test and validate the above is functioning correctly per the project specifications. For example: I ping 192.168.1.1 from PC-A and the result is reply from 192.168.1.1 Part 3: Define the VLANs Describe the VLAN switch configurations here using the format from part 2. Be sure to describe how you test and validate the VLAN implementation. Part 4: Implement VLAN Trunking Describe the VLAN trunking switch configurations here using the same format as the prior two parts. Be sure to describe how you test and validate the VLAN implementation Computer Science Engineering & Technology Networking CMIT 351