OSHA 30 Construction Test Answer Key Fall Hazards Click Safety Red Vector - Flash Cards 2023

Three major components of a Personal Fall Arrest System (PFAS) include; anchor and the anchorage connector; full body harness; and: A. Optional body belt B. Connecting device (lanyard with shock absorber/retractable lifeline, snap hooks) C. Anti-jerk cord D. Any of the above - Correct answer-B. Connecting device (lanyard with shock absorber/retractable lifeline, snap hooks) (correct answer) Get OSHA 30 Exam Passed - Every supported scaffold and its components must support, without failure, its own weight and at least _______ the intended load. A. 2 times B. 3 times C. 4 times D. 6 times - Correct answer-C. 4 times (correct answer) Get OSHA 30 Exam Passed - Examples of fall hazards that have resulted in deaths on the jobsite include: A. Falls to the ground or lower levels B. Falls through existing floor or roof openings C. Falls through the floor or roof surface D. Falls on the same level E. All the above - Correct answer-E. All the above (correct answer) Get OSHA 30 Exam Passed - OSHA requires fall protection at different heights for construction and general industry however, regardless of the fall distance, which of the following is most correct? A. Fall protection must be provided when working over dangerous equipment B. Fall protection must be provided when working over dangerous machinery C. Both A and B are correct D. None of the above - Correct answer-C. Both A and B are correct (correct answer) Get OSHA 30 Exam Passed - If there are defects found during the inspection of personal fall protection equipment, or if the equipment has been used in an arrest, it must be: A. Fixed on the spot and tested by twisting the fabric or rope and looking for stress B. Turned in at the end of the shift C. Removed immediately from service D. None of the above - Correct answer-C. Removed immediately from service (correct answer) Get OSHA 30 Exam Passed - How can YOU prevent a fall from a ladder? A. Choose the right ladder for the job B. Tie the top and bottom of the ladder to fixed points when necessary C. Don't carry tools or other materials in-hand while climbing the ladder D. All the above - Correct answer-D. All the above (correct answer) Get OSHA 30 Exam Passed - More than 33% of fatalities in construction are from a combination of falls from: A. Slips and slides B. Tripping over electrical wires and electrical installations C. Roofs D. None of the above - Correct answer-C. Roofs (correct answer) Get OSHA 30 Exam Passed - Preventing fall hazards is a critical part of the construction planning process. Controls to mitigate fall hazards include installing which of the following? A. Guardrails B. Walls C. Protective covers D. Parapets E. All of the above - Correct answer-E. All of the above (correct answer) Get OSHA 30 Exam Passed - Employees must not work on scaffold surfaces until: A. It is determined to have strength and structural integrity to support intended loads B. OSHA has visited the site and inspected the scaffold C. The surface is completely dry D. All of the above - Correct answer-A. It is determined to have strength and structural integrity to support intended loads (correct answer) Get OSHA 30 Exam Passed - From your choices below, what would you consider to be a "major" fall hazard in construction? A. Roof edges and floor openings B. Steel erection C. Improper scaffold construction D. Unsafe use of portable ladders E. All the above - Correct answer-E. All the above (correct answer) Get OSHA 30 Exam Passed - OSHA requires fall protection when working near the edge of a trench or excavation that is _________or more in depth. A. 4 feet B. 6 feet C. 10 feet D. 20 feet E. None of the above. - Correct answer-B. 6 feet (correct answer) Get OSHA 30 Exam Passed - Climbing on the cross braces of scaffolds is allowed: A. During the assembly of the scaffold B. When conditions are dry and the climbing can be done safely C. Never D. When authorized by the supervisor - Correct answer-C. Never (correct answer) Get OSHA 30 Exam Passed - Horizontal lifelines shall be designed, installed, and used under the supervision of a _______ as part of a complete personal fall arrest system, which maintains a safety factor of at least two. A. Registered Engineer B. OSHA expert C. Qualified Person D. Any of the above - Correct answer-C. Qualified Person (correct answer) Get OSHA 30 Exam Passed - When using scaffolds, make sure there is which of the following? A. Safe and compliant access and egress B. Full planking C. Stable footing D. Guard railing E. All of the above - Correct answer-E. All of the above (correct answer) Get OSHA 30 Exam Passed - D-rings and snap-hooks must have a minimum tensile strength of: A. 500 pounds B. 1500 pounds C. 5,000 pounds D. 25,000 pounds - Correct answer-C. 5,000 pounds (correct answer) Get OSHA 30 Exam Passed - NIOSH is an acronym for which of the following? A. The Occupational Safety and Health Administration B. The National Institute for Occupational Safety and Health C. The National Insurance of Offices and Services D. None of the above - Correct answer-B. The National Institute for Occupational Safety and Health (correct answer) Get OSHA 30 Exam Passed - OSHA's "Focus Four" training topics include Caught-In or - Between, Struck-By, Electrocution and ______. A. Refinery Incidents B. Falls C. Nutrition in the Workplace D. None of the above - Correct answer-B. Falls (correct answer) Get OSHA 30 Exam Passed - A hazard is any situation or condition that has the potential to cause harm to which of the following? A. Life B. Health C. Property D. Environment E. All of the Above - Correct answer-E. All of the Above (correct answer) Get OSHA 30 Exam Passed - Examples of falls that have resulted in deaths on the jobsite include: A. Falls to the ground or lower levels B. Falls through existing floor or roof openings C. Falls through the floor or roof surface D. Falls on the same level E. All of the above - Correct answer-E. All of the above (correct answer) Get OSHA 30 Exam Passed - A hazard is a situation or condition that has the potential to cause harm to which of the following? A. Life B. Health C. Property D. Environment E. All of the Above - Correct answer-E. All of the Above (correct answer) Get OSHA 30 Exam Passed - A theoretical or "What if" hazard is a ______. A. Hazard that is not obvious B. Hazard that may take an event or series of events to occur C. Highly unlikely event and not to be considered D. Both A & B - Correct answer-D. Both A & B (correct answer) Get OSHA 30 Exam Passed - Fall hazards become fall incidents when people _______. A. Forget gravity is always working B. Do not protect themselves from fall hazards C. Become complacent and think they can catch themselves D. All of the above - Correct answer-D. All of the above (correct answer) Get OSHA 30 Exam Passed - In the slide entitled "How long does it take a person to fall?", the example noted that a person could fall 64 feet in approximately how many seconds? A. 1/3 second B. 2 seconds C. 10 seconds D. None of the Above - Correct answer-B. 2 seconds (correct answer) Get OSHA 30 Exam Passed - A fall hazard is anything that could cause you to ______________________ and that has the potential to result in a fall. A. Lose your balance B. Lose bodily support C. Both A and B D. None of the above - Correct answer-C. Both A and B (correct answer) Get OSHA 30 Exam Passed - Fed OSHA requires fall protection on construction sites be used at: A. 4 ft. B. 5 ft. C. 6 ft. D. 7 ft. - Correct answer-C. 6 ft. (correct answer) Get OSHA 30 Exam Passed - OSHA's Focus Four training topics include caught-In or-between, struck-by electrocution, and: A. Motor vehicle accidents B. Refinery incidents C. Falls (correct answer) D. Nutrition in the workplace - Correct answer-C. Falls (correct answer) Get OSHA 30 Exam Passed - Which of the following is an OSHA requirement, regardless of the fall distance? A. Fall protection must be provided when working over dangerous equipment or machinery B. fall protection is optional only when safety experts are present at the job C. None of the above are correct D. Both A and B are correct - Correct answer-A. Fall protection must be provided when working over dangerous equipment or machinery (correct answer) Get OSHA 30 Exam Passed - Studies have shown that complacency, a hazardous behavior, may be caused by which of the following? A. Repetition of work B. Unsafe acts and conditions going uncorrected C. Management not evaluating and enforcing safe work procedures D. All the above - Correct answer-D. All the above (correct answer) Get OSHA 30 Exam Passed - Which of the following can be used to prevent complacency from happening to you or to those around you? A. Hazard recognition planning before the start of a task B. Safety audits of work procedures C. Looking out for your fellow workers D. Taking ownership of your personal safety E. All the above - Correct answer-E. All the above (correct answer) Get OSHA 30 Exam Passed - According to statistics year after year, which of the following would be considered a significant fall hazard in construction? A. Roof edges and floor openings B. Steel erection C. Improper scaffold construction D. Unsafe use of portable ladders E. All the above - Correct answer-E. All the above (correct answer) Get OSHA 30 Exam Passed - Which of the following is a basic element of a roof fall protection program? A. Limiting worker access to the roof and its leading edges B. OSHA certification C. Training employees who access roots on the recognition, evaluation, and control of fall hazards D. Both A and C - Correct answer-D. Both A and C (correct answer)