OHIO CERTIFIED MAINTENANCE TECHNICIAN TEST 08/12/2026
Ohio Certified Maintenance Technician Test questions and
correct answer latest 2026
The piece of equipment on which you are most likely to find a safety (pop off) valve is:
Hot water heater.
Water hammer in domestic water lines is best eliminated by:
Installing an air chamber.
Of the following, the best procedure to follow with a frozen water pipe is:
Open the faucet closest to the frozen pipe and warm the pipe with a blow torch, starting at this point.
In plumbing work, a valve that allows water to flow in one direction only is commonly known as a:
Gate valve.
The pipe fitting that should be used to connect a 1" pipe to a 1 ½" valve is called a:
Reducing coupling.
A tool used in hanging doors is a:
Butt gauge.
, OHIO CERTIFIED MAINTENANCE TECHNICIAN TEST 08/12/2026
A miter box is used:
To hold a saw at a fixed angle while sawing.
Of the following, the best way to lay out a long, straight line of floor is to use:
Chalk and a mason's line.
Roofing nails are usually:
Galvanized.
If moisture is trapped between the layers of a 3-ply roof, the heat of a summer day will:
Cause blisters to be formed in the roofing.
Roll roofing material is usually felt that has been impregnated with:
Mastic.
The purpose of flashing on roof is:
Prevent leaks through the roof.
Water is used to thin which type of paint?
Latex.
Ohio Certified Maintenance Technician Test questions and
correct answer latest 2026
The piece of equipment on which you are most likely to find a safety (pop off) valve is:
Hot water heater.
Water hammer in domestic water lines is best eliminated by:
Installing an air chamber.
Of the following, the best procedure to follow with a frozen water pipe is:
Open the faucet closest to the frozen pipe and warm the pipe with a blow torch, starting at this point.
In plumbing work, a valve that allows water to flow in one direction only is commonly known as a:
Gate valve.
The pipe fitting that should be used to connect a 1" pipe to a 1 ½" valve is called a:
Reducing coupling.
A tool used in hanging doors is a:
Butt gauge.
, OHIO CERTIFIED MAINTENANCE TECHNICIAN TEST 08/12/2026
A miter box is used:
To hold a saw at a fixed angle while sawing.
Of the following, the best way to lay out a long, straight line of floor is to use:
Chalk and a mason's line.
Roofing nails are usually:
Galvanized.
If moisture is trapped between the layers of a 3-ply roof, the heat of a summer day will:
Cause blisters to be formed in the roofing.
Roll roofing material is usually felt that has been impregnated with:
Mastic.
The purpose of flashing on roof is:
Prevent leaks through the roof.
Water is used to thin which type of paint?
Latex.
