PSI JOURNEYMAN LATEST
ONLINE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
An appliance draws 40 amperes when used on a circuit. A bad splice is
discovered on the line at the appliance on one of the phase conductors.
The splice has a measured resistance of 0.5 ohms. How much power is
lost at the splice? - ANSWERS-800 watts
Which type of service-entrance cable has a flame-resistant and moisture
resistant covering? - ANSWERS-Type SE
How many quarter bends are allowed in IMT between pull points? -
ANSWERS-4
Conductors that supply a single motor used in a continuous duty
application shall have an ampacity of not less than what percentage of
the motor full-load current rating? - ANSWERS-125%
What part of a bulk storage plant is classified as Class 2, Zone 2? -
ANSWERS-drainage ditches, separators, and impounding basins
END OF
PAGE
1
, PSI JOURNEYMAN LATEST
ONLINE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
What is the minimum fire rating for electrical vaults housing electrical
equipment over 600 volts, nominal? - ANSWERS-3 hours
For pool equipment, the disconnecting means for all ungrounded
conductors shall be readily accessible and within sight from its
equipment and shall be located a minimum of how many feet
horizontally from the inside walls of a pool? - ANSWERS-5 feet
The ampacity of the conductors from the generator terminals to the first
distribution device(s) containing overcurrent protection shall not be less
than what percentage of the nameplate current rating? - ANSWERS-
115%
The conductors, including splices and taps, shall not fill the wireway to
more than what percentage of its area? - ANSWERS-75%
A feeder supplies a continuous lighting load of 45 amperes and a single
motor load of 30 amperes. What is the ampere rating of the feeder? -
ANSWERS-94 amperes
END OF
PAGE
2
, PSI JOURNEYMAN LATEST
ONLINE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
Lifelines for fall protection shall have a minimum breaking strength of
how many pounds? - ANSWERS-5,400
Disregarding exceptions, overcurrent devices shall be readily accessible
and shall be installed so that the center of the grip of the operating
handle of the switch or circuit breaker, when in its highest position, is
not more than how high above the floor or working platform? -
ANSWERS-6 feet, 7 inches
What is the approximate power consumed by a 15 kw heat strip rated
230 volt that is connected to a 208 volt circuit? - ANSWERS-12 kw
For electric space heating cables, which color of lead wire is used to
indicate a circuit voltage of 240 volt, nominal? - ANSWERS-red
A fitting is a part of a wiring system that is intended primarily to
perform which type of function? - ANSWERS-mechanical
END OF
PAGE
3
ONLINE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
An appliance draws 40 amperes when used on a circuit. A bad splice is
discovered on the line at the appliance on one of the phase conductors.
The splice has a measured resistance of 0.5 ohms. How much power is
lost at the splice? - ANSWERS-800 watts
Which type of service-entrance cable has a flame-resistant and moisture
resistant covering? - ANSWERS-Type SE
How many quarter bends are allowed in IMT between pull points? -
ANSWERS-4
Conductors that supply a single motor used in a continuous duty
application shall have an ampacity of not less than what percentage of
the motor full-load current rating? - ANSWERS-125%
What part of a bulk storage plant is classified as Class 2, Zone 2? -
ANSWERS-drainage ditches, separators, and impounding basins
END OF
PAGE
1
, PSI JOURNEYMAN LATEST
ONLINE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
What is the minimum fire rating for electrical vaults housing electrical
equipment over 600 volts, nominal? - ANSWERS-3 hours
For pool equipment, the disconnecting means for all ungrounded
conductors shall be readily accessible and within sight from its
equipment and shall be located a minimum of how many feet
horizontally from the inside walls of a pool? - ANSWERS-5 feet
The ampacity of the conductors from the generator terminals to the first
distribution device(s) containing overcurrent protection shall not be less
than what percentage of the nameplate current rating? - ANSWERS-
115%
The conductors, including splices and taps, shall not fill the wireway to
more than what percentage of its area? - ANSWERS-75%
A feeder supplies a continuous lighting load of 45 amperes and a single
motor load of 30 amperes. What is the ampere rating of the feeder? -
ANSWERS-94 amperes
END OF
PAGE
2
, PSI JOURNEYMAN LATEST
ONLINE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
Lifelines for fall protection shall have a minimum breaking strength of
how many pounds? - ANSWERS-5,400
Disregarding exceptions, overcurrent devices shall be readily accessible
and shall be installed so that the center of the grip of the operating
handle of the switch or circuit breaker, when in its highest position, is
not more than how high above the floor or working platform? -
ANSWERS-6 feet, 7 inches
What is the approximate power consumed by a 15 kw heat strip rated
230 volt that is connected to a 208 volt circuit? - ANSWERS-12 kw
For electric space heating cables, which color of lead wire is used to
indicate a circuit voltage of 240 volt, nominal? - ANSWERS-red
A fitting is a part of a wiring system that is intended primarily to
perform which type of function? - ANSWERS-mechanical
END OF
PAGE
3
