Written by students who passed Immediately available after payment Read online or as PDF Wrong document? Swap it for free 4.6 TrustPilot
logo-home
Document preview thumbnail
Preview 3 out of 20 pages
Exam (elaborations)

ELEVATOR MECHANIC REVIEW /023 CERTIFICATION SCRIPT 2026 QUESTIONS WITH SOLUTIONS GRADED A+

Document preview thumbnail
Preview 3 out of 20 pages

ELEVATOR MECHANIC REVIEW /023 CERTIFICATION SCRIPT 2026 QUESTIONS WITH SOLUTIONS GRADED A+

Content preview

ELEVATOR MECHANIC REVIEW /023
CERTIFICATION SCRIPT 2026
QUESTIONS WITH SOLUTIONS
GRADED A+

◍ A waveform that has unequal rise and fall times with one being
instantaneous is called a (blank) wave..
Answer: Sawtooth
◍ Refer to figure 1. Which of the following statements is correct?.
Answer: Sine wave A is lagging sine wave B.
◍ Which of the following statements is correct regarding wye stator
connections?.
Answer: Ther is a neutral or common connection for all three phases
◍ If a two-speed AC motor having a ratio of 8:1 has a rated speed of 225 FPM,
what is the leveling speed?.
Answer: 28 FPM
◍ Why are even minor electrical shocks dangerous?.
Answer: The involuntary reflex to pull away
◍ Which safety device detects small imbalances between the hot and neutral
current carrying conductors?.
Answer: GFCI
◍ Which of the following is a correct statement about magnetic poles?.
Answer: Like poles repel
◍ Refer to figure 2. If current is flowing continuously from left to right
through the conductor, which of the following statements is correct?.

, Answer: The magnetic lines of force will be in the counter clockwise
direction
◍ Which device can be used to measure current in a circuit without
disconnecting any wiring?.
Answer: Clamp-on Meter
◍ The moveable portion of a relay is referred to as the (blank)..
Answer: Armature
◍ The difference of electrical potential between two points is called (blank).
Answer: Voltage
◍ A wire-wound resistor in a series circuit with a supply voltage of 45 VDC
has a nominal value of 64 ohms. It develops a problem, which results in it
being 40% partially shorted. The circuit fuse is rated at 1 amp. Which of the
following statements is correct?.
Answer: This represents a shorted condition that will not open the fuse
◍ Which of the following is equivalent to 35 micro amps?.
Answer: .000035 amperes
◍ The period of a sine wave is .0083 seconds. What is the frequency?.
Answer: 120 Hz
◍ With an effective value of 20.2 amps of AC current, what is the peak value?.
Answer: 28.6 amps
◍ You are putting up a stringer of lights in a hoistway with lights spaced at 6
foot intervals. If using 100 watt light bulbs, how many feet of the hoistway
can you cover before tripping the breaker on a 20A circuit?.
Answer: 24
◍ The symbol E is used to represent which of the following in electricity?.
Answer: Voltage
◍ Two negative charges placed next to each other will ... (blank).
Answer: Repel each other

, ◍ One ampere equals (blank).
Answer: 1,000 mA
◍ Switches are generally rated by the maximum (blank) across the contacts
when the switch is open and the maximum (blank) through the switch when
it is closed..
Answer: Voltage, current
◍ What happens to the total resistance in a wire if it's length is doubled?.
Answer: The resistance is doubled
◍ What happens to the total resistance in a wire if it's cross-sectional area is
increased by four times?.
Answer: The resistance is one-fourth of what it was originally.
◍ In the circuit shown in figure 3, what is the voltage drop across the switch?.
Answer: 0 VDC, since there is no resistance in the switch.
◍ Solve the following -863 x -1224= (blank).
Answer: + 1,056,312
◍ Calculate the resistance in a circuit if the voltage is 24 VDC and 40 watts of
power are consumed..
Answer: 1.66 ohms
◍ What will happen to the current in a circuit of constant voltage if the
resistance is halved?.
Answer: The current will double
◍ How should ohmmeters be used to take measurements in a circuit?.
Answer: Connected in parallel across the load with one lead of the load to be
measured disconnected
◍ Refer to figure 4. What is the source voltage in this circuit if the total power
consumed in this circuit is 270 milliwatts?.
Answer: 25 volts
◍ Refer to figure 4. What is the current through R2?.
Answer: 2.8 mA

Document information

Uploaded on
August 10, 2026
Number of pages
20
Written in
2026/2027
Type
Exam (elaborations)
Contains
Questions & answers
$15.99

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
GradeGalaxy
4.4
(9)
Sold
139
Followers
4
Items
46027
Last sold
6 hours ago


Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions