NCCCO CORE EXAM (2026) UPDATE VERIFIED QUESTIONS AND
ANSWERS LATEST ALREADY GRADED A+ UPDATE 2026
Before leveling a mobile crane on outriggers, an operator should ensure: - CORRECT ANSWERS-
there is no weight of the crane bearing on any tires
Operating a mobile crane with a long boom, on uneven ground, what support condition should
be considered? - CORRECT ANSWERS-Keeping 90 degree angle between cylinder rod and pad
What is the primary purpose fir a rooster sheave or auxiliary boom point sheave? - CORRECT
ANSWERS-Separate the boom hoist lines
How many randomly broken wires in a lay length must there be on a mobile cranes hoist line,
before it should be removed from service? - CORRECT ANSWERS-6
On a mobile crane, how many broken wires are permitted at the end connection of a pendent
before it must be taken out of service? - CORRECT ANSWERS-1
Type 1 rotation resistant hoist wire rope has a design factor of: - CORRECT ANSWERS-5 to 1
How many randomly distributed broken wires in rotation- resistant hoist wire rope are
considered for replacement? - CORRECT ANSWERS-2 broken wires in 6 rope diameters
The term net capacity is best defined by which of the terms listed below? - CORRECT ANSWERS-
Gross capacity minus capacity deductions
Mobile cranes that are set up on barges, shall have a list chart provided by which of the entities
listed below? - CORRECT ANSWERS-Manufacturer
, When lifting loads on tires, mobile cranes are rated at what percentage of tipping? - CORRECT
ANSWERS-75%
How does the effective weight of a slowed extension relate to the actual weight of the
extension? - CORRECT ANSWERS-Higher than the actual weight.
When load radius is between radii values, the operator must use the: - CORRECT ANSWERS-
longer radius
Why should only approved attachments or extra counterweights provided by the manufacturer
be placed on the rear of the crane? - CORRECT ANSWERS-They could cause a backward stability
problem.
A mobile crane's jib is offset 15º versus its original 0º offset, but the boom angle remains
unchanged. In this situation, the load radius: - CORRECT ANSWERS-increases
Abruptly stopping a rapid swing on a long-boom mobile crane will produce what major effect? -
CORRECT ANSWERS-Collapsing the boom.
When determining the position to a mobile crane should be left in over night, when high winds
in the forecast the operator should: - CORRECT ANSWERS-Follow the manufacturers
recommendations.
If a mobile crane is NOT set-up level and the operator swings the load from the high side to the
low side, what effect will that have on the radius? - CORRECT ANSWERS-The radius increase.
Increasing the distance from the crane's center of gravity to the tipping axis will have what
effect on the mobile crane? - CORRECT ANSWERS-Decreases stability.
ANSWERS LATEST ALREADY GRADED A+ UPDATE 2026
Before leveling a mobile crane on outriggers, an operator should ensure: - CORRECT ANSWERS-
there is no weight of the crane bearing on any tires
Operating a mobile crane with a long boom, on uneven ground, what support condition should
be considered? - CORRECT ANSWERS-Keeping 90 degree angle between cylinder rod and pad
What is the primary purpose fir a rooster sheave or auxiliary boom point sheave? - CORRECT
ANSWERS-Separate the boom hoist lines
How many randomly broken wires in a lay length must there be on a mobile cranes hoist line,
before it should be removed from service? - CORRECT ANSWERS-6
On a mobile crane, how many broken wires are permitted at the end connection of a pendent
before it must be taken out of service? - CORRECT ANSWERS-1
Type 1 rotation resistant hoist wire rope has a design factor of: - CORRECT ANSWERS-5 to 1
How many randomly distributed broken wires in rotation- resistant hoist wire rope are
considered for replacement? - CORRECT ANSWERS-2 broken wires in 6 rope diameters
The term net capacity is best defined by which of the terms listed below? - CORRECT ANSWERS-
Gross capacity minus capacity deductions
Mobile cranes that are set up on barges, shall have a list chart provided by which of the entities
listed below? - CORRECT ANSWERS-Manufacturer
, When lifting loads on tires, mobile cranes are rated at what percentage of tipping? - CORRECT
ANSWERS-75%
How does the effective weight of a slowed extension relate to the actual weight of the
extension? - CORRECT ANSWERS-Higher than the actual weight.
When load radius is between radii values, the operator must use the: - CORRECT ANSWERS-
longer radius
Why should only approved attachments or extra counterweights provided by the manufacturer
be placed on the rear of the crane? - CORRECT ANSWERS-They could cause a backward stability
problem.
A mobile crane's jib is offset 15º versus its original 0º offset, but the boom angle remains
unchanged. In this situation, the load radius: - CORRECT ANSWERS-increases
Abruptly stopping a rapid swing on a long-boom mobile crane will produce what major effect? -
CORRECT ANSWERS-Collapsing the boom.
When determining the position to a mobile crane should be left in over night, when high winds
in the forecast the operator should: - CORRECT ANSWERS-Follow the manufacturers
recommendations.
If a mobile crane is NOT set-up level and the operator swings the load from the high side to the
low side, what effect will that have on the radius? - CORRECT ANSWERS-The radius increase.
Increasing the distance from the crane's center of gravity to the tipping axis will have what
effect on the mobile crane? - CORRECT ANSWERS-Decreases stability.
