Comprehensive ATC and Aviation Procedures: Notes Review
Study online at https://quizlet.com/_jmal8o
1. What elements should ATIS mes- Average Delay, Type of approach, Arrival/departure in-
sages contain? dicator, Transition level, Runway in use
2. How must identification by the 1nm from the end of the runway
departing aircraft method be
achieved?
3. What is the conversion of knots to 1 knot = 1 nautical mile per hour
nautical miles per hour?
4. What is a slot in the context of A calculated takeoff time (CTOT) with a tolerance of -5
ATFM? to 10 minutes
5. What level does the establishment Strategic ASM (level 1)
of national policy and structures in
ASM take place?
6. What should a controller do if the Instruct the pilot to reset the code
mode A code does not match the
allocated code?
7. Does a turn for identification consti- False
tute the provision of a radar service?
8. When is an aircraft considered to be When communication attempts fail or if unlawful inter-
in the emergency phase ALERFA? ference is suspected
9. How is vectoring achieved? By allocating magnetic headings to the aircraft
10. What are exact reporting points? Any intersection of 2 VOR radials, Overhead an NDB,
Overhead a VOR
11. What is a conditional route (CDR)? A permanent ATS route used only under certified spec-
ified conditions
1/6
, Comprehensive ATC and Aviation Procedures: Notes Review
Study online at https://quizlet.com/_jmal8o
12. When can an aircraft be said to have When Mode C indicates more than 300ft away from
vacated a level using mode C? the level and is continuing in the right direction
13. When can an aircraft be said to have Mode C readout +/- 200 feet for 3 successive sweeps
reached an assigned level in RSVM or 15 seconds
airspace?
14. What information does Flight Info Info on radioactive/toxic chemicals, SIGMET and
Service provide? AIRMET info, Info on unmanned balloons
15. When should a pilot be informed of When the pilot's estimate differs from the controller's
his position? estimate, when identified by the turn method, or when
requested by the pilot
16. What is an AIC? A notice containing information related to flight safety,
air navigation, or administrative matters
17. What Air Traffic Services are provid- Air Traffic Advisory Service and Flight Information Ser-
ed in Category F airspace? vice
18. What conditions must be met for a It must be displayed on the situation display and ap-
prominent geographical position to proved for the purpose
be used for identification?
19. When is an aircraft in the uncertain- When fuel is exhausted or insufficient, or fails to arrive
ty phase (INCERFA)? within 30 minutes of ETA
20. What frequency does a VHF emer- 121.5
gency locator beacon transmit?
21. Who is responsible for the prepara- Air Traffic Services
tion and dissemination of the ATIS
message?
2/6
Study online at https://quizlet.com/_jmal8o
1. What elements should ATIS mes- Average Delay, Type of approach, Arrival/departure in-
sages contain? dicator, Transition level, Runway in use
2. How must identification by the 1nm from the end of the runway
departing aircraft method be
achieved?
3. What is the conversion of knots to 1 knot = 1 nautical mile per hour
nautical miles per hour?
4. What is a slot in the context of A calculated takeoff time (CTOT) with a tolerance of -5
ATFM? to 10 minutes
5. What level does the establishment Strategic ASM (level 1)
of national policy and structures in
ASM take place?
6. What should a controller do if the Instruct the pilot to reset the code
mode A code does not match the
allocated code?
7. Does a turn for identification consti- False
tute the provision of a radar service?
8. When is an aircraft considered to be When communication attempts fail or if unlawful inter-
in the emergency phase ALERFA? ference is suspected
9. How is vectoring achieved? By allocating magnetic headings to the aircraft
10. What are exact reporting points? Any intersection of 2 VOR radials, Overhead an NDB,
Overhead a VOR
11. What is a conditional route (CDR)? A permanent ATS route used only under certified spec-
ified conditions
1/6
, Comprehensive ATC and Aviation Procedures: Notes Review
Study online at https://quizlet.com/_jmal8o
12. When can an aircraft be said to have When Mode C indicates more than 300ft away from
vacated a level using mode C? the level and is continuing in the right direction
13. When can an aircraft be said to have Mode C readout +/- 200 feet for 3 successive sweeps
reached an assigned level in RSVM or 15 seconds
airspace?
14. What information does Flight Info Info on radioactive/toxic chemicals, SIGMET and
Service provide? AIRMET info, Info on unmanned balloons
15. When should a pilot be informed of When the pilot's estimate differs from the controller's
his position? estimate, when identified by the turn method, or when
requested by the pilot
16. What is an AIC? A notice containing information related to flight safety,
air navigation, or administrative matters
17. What Air Traffic Services are provid- Air Traffic Advisory Service and Flight Information Ser-
ed in Category F airspace? vice
18. What conditions must be met for a It must be displayed on the situation display and ap-
prominent geographical position to proved for the purpose
be used for identification?
19. When is an aircraft in the uncertain- When fuel is exhausted or insufficient, or fails to arrive
ty phase (INCERFA)? within 30 minutes of ETA
20. What frequency does a VHF emer- 121.5
gency locator beacon transmit?
21. Who is responsible for the prepara- Air Traffic Services
tion and dissemination of the ATIS
message?
2/6
