To prevent tip over when driving a rough terrain forklift, keep the load _______
Give this one a try later!
low
How many sides on a hexagonal shape
Give this one a try later!
Six
You must maintain eye contact with the operator when using _____ signals
,Give this one a try later!
hand
A power miter saw combines a miter box with a.
Give this one a try later!
circular saw
Before using a pneumatically powered nailer for the first time, it is important to
Give this one a try later!
Read the manufacturer's instructions
Another common name for lineman pliers is
Give this one a try later!
side cutters
In addition to level and plumb, some spirit levels can check a
Give this one a try later!
, 45 degree angle
When using power tools,never engage the
Give this one a try later!
trigger lock
When placing a ladder against a platform or roof, the top of the ladder should extend
above the point where the ladder touches the platform or roof by at least
Give this one a try later!
3 feet
When used in oxyfuel cutting propylene mixtures burn at temperatures around
Give this one a try later!
5,193
A grinder can catch on rough material edges and shift around, especially when using
rotary bits called
Give this one a try later!
, Burr bits
One of the most common grounding systems used for protection against accidental
electrical shock is
Give this one a try later!
three-wire system
A saw the has a thin, one-piece blade that runs around guides at either end of the saw
is a.
Give this one a try later!
bandsaw
When using a circular saw,be sure to cut on the waste side of the cut mark to allow of
the blade's.
Give this one a try later!
Kerf
To check level conditions over a significant distance, such as a building foundation or
longer distance, the best level to use is...
Give this one a try later!
low
How many sides on a hexagonal shape
Give this one a try later!
Six
You must maintain eye contact with the operator when using _____ signals
,Give this one a try later!
hand
A power miter saw combines a miter box with a.
Give this one a try later!
circular saw
Before using a pneumatically powered nailer for the first time, it is important to
Give this one a try later!
Read the manufacturer's instructions
Another common name for lineman pliers is
Give this one a try later!
side cutters
In addition to level and plumb, some spirit levels can check a
Give this one a try later!
, 45 degree angle
When using power tools,never engage the
Give this one a try later!
trigger lock
When placing a ladder against a platform or roof, the top of the ladder should extend
above the point where the ladder touches the platform or roof by at least
Give this one a try later!
3 feet
When used in oxyfuel cutting propylene mixtures burn at temperatures around
Give this one a try later!
5,193
A grinder can catch on rough material edges and shift around, especially when using
rotary bits called
Give this one a try later!
, Burr bits
One of the most common grounding systems used for protection against accidental
electrical shock is
Give this one a try later!
three-wire system
A saw the has a thin, one-piece blade that runs around guides at either end of the saw
is a.
Give this one a try later!
bandsaw
When using a circular saw,be sure to cut on the waste side of the cut mark to allow of
the blade's.
Give this one a try later!
Kerf
To check level conditions over a significant distance, such as a building foundation or
longer distance, the best level to use is...
