TTT1 Study Guide Newest 2026 Questions and
Correct Detailed Answers Already Graded A+
What is the maximum distance between the sternal d-ring and the fixed safety
climb? - CORRECT ANSWER-Nine inches
When calculating a fall distance using a "6 foot" energy absorbed, what is the
maximum pull out distance? - CORRECT ANSWER-Four feey
What is the minimum force that a work positioning system anchorage must be
able to withstand? - CORRECT ANSWER-Two times the arresting force of
3000lbs
What minimum force must a non-engineered anchor be able to withstand for fall
protection use? - CORRECT ANSWER-5,000 lbs
When working, how often should fall protection equipment be inspected ? -
CORRECT ANSWER-Daily before each use
, According to the applicable industry standard, what is the minimum height from a
lower surface or ground where fall protection must be used? - CORRECT
ANSWER-Six feet
How many pounds force is one kilo Newton(kN) - CORRECT ANSWER-225
Who is the third party group that approves and endorses standards? - CORRECT
ANSWER-American National Standards Institute
What term is used to describe the documents written by members, or peers, in
the industry? - CORRECT ANSWER-Standards
A company's health, safety and environment policy should be a combination of
labor regulations and ? - CORRECT ANSWER-Industry standards
Where OSHA has not promulgated specific standards, who is responsible for
following the acts general clause? - CORRECT ANSWER-Employer
On a job site who should be involved in the JHA process? - CORRECT ANSWER-
The Whole Crew
What does the Term SOW stand for? - CORRECT ANSWER-Scope Of Work
Correct Detailed Answers Already Graded A+
What is the maximum distance between the sternal d-ring and the fixed safety
climb? - CORRECT ANSWER-Nine inches
When calculating a fall distance using a "6 foot" energy absorbed, what is the
maximum pull out distance? - CORRECT ANSWER-Four feey
What is the minimum force that a work positioning system anchorage must be
able to withstand? - CORRECT ANSWER-Two times the arresting force of
3000lbs
What minimum force must a non-engineered anchor be able to withstand for fall
protection use? - CORRECT ANSWER-5,000 lbs
When working, how often should fall protection equipment be inspected ? -
CORRECT ANSWER-Daily before each use
, According to the applicable industry standard, what is the minimum height from a
lower surface or ground where fall protection must be used? - CORRECT
ANSWER-Six feet
How many pounds force is one kilo Newton(kN) - CORRECT ANSWER-225
Who is the third party group that approves and endorses standards? - CORRECT
ANSWER-American National Standards Institute
What term is used to describe the documents written by members, or peers, in
the industry? - CORRECT ANSWER-Standards
A company's health, safety and environment policy should be a combination of
labor regulations and ? - CORRECT ANSWER-Industry standards
Where OSHA has not promulgated specific standards, who is responsible for
following the acts general clause? - CORRECT ANSWER-Employer
On a job site who should be involved in the JHA process? - CORRECT ANSWER-
The Whole Crew
What does the Term SOW stand for? - CORRECT ANSWER-Scope Of Work
