TABLE SAW SAFETY AND OPERATION TEST LATEST 2026 UPDATED
QUESTIONS AND VERIFIED 100% SOLUTIONS (2026/2027) |A+
GRADED |GUARANTEED PASS
When sawing with the Table Saw, which of the following would NOT be a safe practice?
Stand in line with the saw blade.
After a cut has been completed, what should the operator do before leaving the Table Saw?
Make sure the saw blade has stopped turning.
When making a rip or cross cut, the saw blade should extend no more than ________ inches
above the stock being cut.
1/4
When bevel or chamfer cuts are made, the hands of the operator should be ....
Opposite side from which the blade is tilted.
Which type of stock should never be ripped on the Table Saw?
Round stock, warped or Twister
Which of the following operations require the use of a push stick on the Table Saw?
Ripping narrow materials.
Which Table Saw accessory gives width settings for the rip fence?
Front rail.
A push stick must be used if material is less than _______ inches in width.
6
The Rip fence and miter gauge
Can't be used at the same time
How far should you keep your fingers away from the blade?
12 inches
The main purpose of the table saw is to ____________
Rip Various Materials
1|Page
QUESTIONS AND VERIFIED 100% SOLUTIONS (2026/2027) |A+
GRADED |GUARANTEED PASS
When sawing with the Table Saw, which of the following would NOT be a safe practice?
Stand in line with the saw blade.
After a cut has been completed, what should the operator do before leaving the Table Saw?
Make sure the saw blade has stopped turning.
When making a rip or cross cut, the saw blade should extend no more than ________ inches
above the stock being cut.
1/4
When bevel or chamfer cuts are made, the hands of the operator should be ....
Opposite side from which the blade is tilted.
Which type of stock should never be ripped on the Table Saw?
Round stock, warped or Twister
Which of the following operations require the use of a push stick on the Table Saw?
Ripping narrow materials.
Which Table Saw accessory gives width settings for the rip fence?
Front rail.
A push stick must be used if material is less than _______ inches in width.
6
The Rip fence and miter gauge
Can't be used at the same time
How far should you keep your fingers away from the blade?
12 inches
The main purpose of the table saw is to ____________
Rip Various Materials
1|Page
