What are the three tap taper geometries?
Give this one a try later!
Taper, plug, and bottoming
Activates linear interpolation
Give this one a try later!
G01
The equation for IPM (feed rate in inch per minute)
, Give this one a try later!
IPM = RPM(N)(FPT)
N = number of teeth
FPT = feed per tooth
What is incremental positioning? What is its G code?
Give this one a try later!
This type of positioning does not use a set part zero. Instead, each machine
movement is based on the previous movement. When moving in these
positions, the last point becomes the new point of reference. The G code is
G91.
What are the nine groups of keys on a Haas machine?
Give this one a try later!
Reset keys, Display Mode keys, Operations Mode keys, Numeric keys,
Alpha keys, Cursor keys, Overrides, Jog keys, Function keys
What are some synonyms for work offset?
Give this one a try later!
Part zero and work zero
Give this one a try later!
Taper, plug, and bottoming
Activates linear interpolation
Give this one a try later!
G01
The equation for IPM (feed rate in inch per minute)
, Give this one a try later!
IPM = RPM(N)(FPT)
N = number of teeth
FPT = feed per tooth
What is incremental positioning? What is its G code?
Give this one a try later!
This type of positioning does not use a set part zero. Instead, each machine
movement is based on the previous movement. When moving in these
positions, the last point becomes the new point of reference. The G code is
G91.
What are the nine groups of keys on a Haas machine?
Give this one a try later!
Reset keys, Display Mode keys, Operations Mode keys, Numeric keys,
Alpha keys, Cursor keys, Overrides, Jog keys, Function keys
What are some synonyms for work offset?
Give this one a try later!
Part zero and work zero
