Texas General Contractor Licensing
Exam Practice Questions And Correct
Answers (Verified Answers) Plus
Rationale 2026 Q&A| Instant Download
Pdf
1. A general contractor in Texas is preparing a bid for a municipal
construction project requiring compliance with state procurement
regulations. During the review of the project manual, the contractor
notices that the specifications require adherence to prevailing wage
provisions, bonding requirements, and mandatory minority
subcontractor participation goals. Before submitting the bid, which
action is the MOST important to ensure legal compliance and reduce
the risk of bid rejection or future disputes?
A. Submit the bid immediately and negotiate compliance requirements after
contract award
,B. Ignore minority participation goals because they are optional
recommendations only
C. Carefully review all procurement requirements, confirm subcontractor
qualifications, and verify bonding capacity before bid submission
D. Reduce labor costs below prevailing wage rates to remain competitive
C. Carefully review all procurement requirements, confirm subcontractor
qualifications, and verify bonding capacity before bid submission
The contractor must fully understand and comply with all bid specifications
before submitting a proposal. Public projects frequently require prevailing
wages, bonding, and participation goals, and failure to comply may result
in bid rejection, penalties, or contract termination.
2. A Texas general contractor is overseeing excavation activities near
underground utilities on a commercial project site. The excavation
subcontractor plans to begin trenching operations immediately to
maintain schedule deadlines. According to Texas safety requirements
and standard construction practices, what should occur BEFORE
excavation work begins?
A. Excavation may proceed if workers wear personal protective equipment
B. Utility locations should be identified through notification systems and site
verification procedures
C. Excavation can begin without inspection if the trench depth is less than 10
,feet
D. Only the project owner is responsible for locating underground utilities
B. Utility locations should be identified through notification systems and
site verification procedures
Excavation work presents serious hazards involving underground utilities
such as gas, water, and electrical lines. Contractors must contact utility
locating services and verify utility locations before digging to prevent
injuries, service interruptions, and property damage.
3. During construction of a multi-story office building in Texas, the
project architect rejects several installed structural steel members
because they do not meet specified tolerances. The subcontractor
argues that the deviations are minor and should be accepted. Under
standard contract administration procedures, who generally has
authority to determine whether work complies with the contract
documents?
A. The steel supplier
B. The subcontractor’s foreman
C. The architect or authorized design professional
D. The owner’s accountant
C. The architect or authorized design professional
, The architect or designated design professional typically has authority to
evaluate whether construction work conforms to the plans and
specifications. Contractors are obligated to correct defective or
nonconforming work at their expense if required by the contract.
4. A general contractor is calculating the estimated concrete quantity
needed for a rectangular slab measuring 120 feet long, 80 feet wide,
and 6 inches thick. Approximately how many cubic yards of concrete
are required for the slab?
A. 89 cubic yards
B. 133 cubic yards
C. 178 cubic yards
D. 240 cubic yards
C. 178 cubic yards
Concrete volume is calculated by converting thickness to feet and
multiplying length × width × thickness. The slab volume equals 120 × 80 ×
0.5 = 4,800 cubic feet. Dividing by 27 cubic feet per cubic yard gives
approximately 178 cubic yards.
5. A Texas contractor discovers that moisture intrusion is occurring
behind exterior wall cladding shortly after project completion.
Investigation reveals that flashing was improperly installed around
windows. Which construction principle was MOST likely violated?
Exam Practice Questions And Correct
Answers (Verified Answers) Plus
Rationale 2026 Q&A| Instant Download
1. A general contractor in Texas is preparing a bid for a municipal
construction project requiring compliance with state procurement
regulations. During the review of the project manual, the contractor
notices that the specifications require adherence to prevailing wage
provisions, bonding requirements, and mandatory minority
subcontractor participation goals. Before submitting the bid, which
action is the MOST important to ensure legal compliance and reduce
the risk of bid rejection or future disputes?
A. Submit the bid immediately and negotiate compliance requirements after
contract award
,B. Ignore minority participation goals because they are optional
recommendations only
C. Carefully review all procurement requirements, confirm subcontractor
qualifications, and verify bonding capacity before bid submission
D. Reduce labor costs below prevailing wage rates to remain competitive
C. Carefully review all procurement requirements, confirm subcontractor
qualifications, and verify bonding capacity before bid submission
The contractor must fully understand and comply with all bid specifications
before submitting a proposal. Public projects frequently require prevailing
wages, bonding, and participation goals, and failure to comply may result
in bid rejection, penalties, or contract termination.
2. A Texas general contractor is overseeing excavation activities near
underground utilities on a commercial project site. The excavation
subcontractor plans to begin trenching operations immediately to
maintain schedule deadlines. According to Texas safety requirements
and standard construction practices, what should occur BEFORE
excavation work begins?
A. Excavation may proceed if workers wear personal protective equipment
B. Utility locations should be identified through notification systems and site
verification procedures
C. Excavation can begin without inspection if the trench depth is less than 10
,feet
D. Only the project owner is responsible for locating underground utilities
B. Utility locations should be identified through notification systems and
site verification procedures
Excavation work presents serious hazards involving underground utilities
such as gas, water, and electrical lines. Contractors must contact utility
locating services and verify utility locations before digging to prevent
injuries, service interruptions, and property damage.
3. During construction of a multi-story office building in Texas, the
project architect rejects several installed structural steel members
because they do not meet specified tolerances. The subcontractor
argues that the deviations are minor and should be accepted. Under
standard contract administration procedures, who generally has
authority to determine whether work complies with the contract
documents?
A. The steel supplier
B. The subcontractor’s foreman
C. The architect or authorized design professional
D. The owner’s accountant
C. The architect or authorized design professional
, The architect or designated design professional typically has authority to
evaluate whether construction work conforms to the plans and
specifications. Contractors are obligated to correct defective or
nonconforming work at their expense if required by the contract.
4. A general contractor is calculating the estimated concrete quantity
needed for a rectangular slab measuring 120 feet long, 80 feet wide,
and 6 inches thick. Approximately how many cubic yards of concrete
are required for the slab?
A. 89 cubic yards
B. 133 cubic yards
C. 178 cubic yards
D. 240 cubic yards
C. 178 cubic yards
Concrete volume is calculated by converting thickness to feet and
multiplying length × width × thickness. The slab volume equals 120 × 80 ×
0.5 = 4,800 cubic feet. Dividing by 27 cubic feet per cubic yard gives
approximately 178 cubic yards.
5. A Texas contractor discovers that moisture intrusion is occurring
behind exterior wall cladding shortly after project completion.
Investigation reveals that flashing was improperly installed around
windows. Which construction principle was MOST likely violated?
