7/10/26, 7:01 PM NYC Master Electrical Exam (Latest Update 2026) UPDATE!! (Recent exam) Fully solved & updated 2026 Most TESTED (2026 Fla…
NYC Master Electrical Exam (Latest Update 2026)
UPDATE!! (Recent exam) Fully solved & updated
2026 Most TESTED (2026
Save Add to calendar
Terms in this set (403)
neutral point The common point on a wye-connection in a
polyphase system or midpoint on a single phase,
3-wire system, or midpoint of a single phase
portion of a 3-phase delta system, or a midpoint of
a 3-wire, direct current system
In the NEC the words Shall or shall not
___________indicate a mandatory
requirement
On a four wire Delta connected Orange
system with a midpoint of one phase
winding is grounded, only the
conductor or bus bar having a higher
phase voltage the ground shall be
durably and permanently marked by
an outer finish that is _______ in color or
by other effective means. Such
Identification shall be placed at each
point on the system where
connection is made if the grounded
conductor is also present.
https://quizlet.com/1194117538/nyc-master-electrical-exam-latest-update-2026-update-recent-exam-fully-solved-updated-2026-most-tested-2026-flas… 1/70
,7/10/26, 7:01 PM NYC Master Electrical Exam (Latest Update 2026) UPDATE!! (Recent exam) Fully solved & updated 2026 Most TESTED (2026 Fla…
The required working space for 3 feet 6 inches
access to live parts operating at 300
V to ground, where there are
exposed live parts on one side and
grounded parts on the other side is
____________.
The dimensions of working space for 4 feet
access to live parts operating at 300
V, nominal to ground, where there
are expose live parts on both sides
of the workspace is________________.
110.26 A1- Dead front assemblies 30" for non-electrical parts
working space 36" for electrical parts
The working space in front of the 30"
electrical equipment shall not be
less than _______wide, or of the width
of the equipment, whichever is
greater.
Large equipment 1200 A or greater and over 6 feet wide
Large equipment means of egress Two means of egress 24" wide by 6.5 feet tall
unless the following condutions are met
1) unobstructed egress
2) Double the workspace
Headroom shall not be less than 6.5 feet or the height of the equipment
_______.
https://quizlet.com/1194117538/nyc-master-electrical-exam-latest-update-2026-update-recent-exam-fully-solved-updated-2026-most-tested-2026-flas… 2/70
,7/10/26, 7:01 PM NYC Master Electrical Exam (Latest Update 2026) UPDATE!! (Recent exam) Fully solved & updated 2026 Most TESTED (2026 Fla…
Live parts of electrical equipment 50 volts
operating at ______volts or more she'll 4) by elevation of 8 feet or more above the floor or
be guarded against accidental other working surface
contact or approved enclosures or
by any of the following means
A fence shall not be less than 8 feet
______feet in height
One entrance to enclosures for 30 inches and 6.5 feet
electrical installations as described
in 110.31 not less than _______wide and
_________high shall be provided to give
access to the working space around
the electrical equipment
Network compartments shall have at Two
least ________means of access. Each
door she'll have an access that leads
to a legal exit.
Where rear access is required to 30 inches
work on deenergized parts on the
back of enclosed equipment a
minimum working space of
__________horizontally shall be provided
All non-current carrying metal parts 1000 feet
of electrical equipment and all metal
raceways and cable shall be solidly
grounded and bonded to all metal
pipes in rails at the portal and the
intervals not exceeding
_____________throughout the tunnel.
https://quizlet.com/1194117538/nyc-master-electrical-exam-latest-update-2026-update-recent-exam-fully-solved-updated-2026-most-tested-2026-flas… 3/70
, 7/10/26, 7:01 PM NYC Master Electrical Exam (Latest Update 2026) UPDATE!! (Recent exam) Fully solved & updated 2026 Most TESTED (2026 Fla…
Manhole workspace for cabling-A 3 feet
clear workspace not less than 2-1/2 feet
_______wide shall be provided were
cables are located on both sides and
not less than _______were cables are
only on one side.
Access to manhole dimensions. 26" x 22"
Rectangular access openings shall 26"
not be less than _______. Round access
openings in a manhole shall be not
less than ______inches in diameter
Manhole openings for personnel Protective barrier of fixed ladder
shall be located where they are not
directly above electrical equipment
or conductors in the enclosure.
Where this is not practiceable either
a ________or a _______shall be provided.
And insulated grounded conductor 6 awg
of _____or smaller shall be identified
by a continuous white or gray outer
finish or by three continuous white
stripes on other than green insulation
along its entire length.
Manhole covers shall be over 100 pounds
______pounds or otherwise designated
to require the use of tools to open.
https://quizlet.com/1194117538/nyc-master-electrical-exam-latest-update-2026-update-recent-exam-fully-solved-updated-2026-most-tested-2026-flas… 4/70
NYC Master Electrical Exam (Latest Update 2026)
UPDATE!! (Recent exam) Fully solved & updated
2026 Most TESTED (2026
Save Add to calendar
Terms in this set (403)
neutral point The common point on a wye-connection in a
polyphase system or midpoint on a single phase,
3-wire system, or midpoint of a single phase
portion of a 3-phase delta system, or a midpoint of
a 3-wire, direct current system
In the NEC the words Shall or shall not
___________indicate a mandatory
requirement
On a four wire Delta connected Orange
system with a midpoint of one phase
winding is grounded, only the
conductor or bus bar having a higher
phase voltage the ground shall be
durably and permanently marked by
an outer finish that is _______ in color or
by other effective means. Such
Identification shall be placed at each
point on the system where
connection is made if the grounded
conductor is also present.
https://quizlet.com/1194117538/nyc-master-electrical-exam-latest-update-2026-update-recent-exam-fully-solved-updated-2026-most-tested-2026-flas… 1/70
,7/10/26, 7:01 PM NYC Master Electrical Exam (Latest Update 2026) UPDATE!! (Recent exam) Fully solved & updated 2026 Most TESTED (2026 Fla…
The required working space for 3 feet 6 inches
access to live parts operating at 300
V to ground, where there are
exposed live parts on one side and
grounded parts on the other side is
____________.
The dimensions of working space for 4 feet
access to live parts operating at 300
V, nominal to ground, where there
are expose live parts on both sides
of the workspace is________________.
110.26 A1- Dead front assemblies 30" for non-electrical parts
working space 36" for electrical parts
The working space in front of the 30"
electrical equipment shall not be
less than _______wide, or of the width
of the equipment, whichever is
greater.
Large equipment 1200 A or greater and over 6 feet wide
Large equipment means of egress Two means of egress 24" wide by 6.5 feet tall
unless the following condutions are met
1) unobstructed egress
2) Double the workspace
Headroom shall not be less than 6.5 feet or the height of the equipment
_______.
https://quizlet.com/1194117538/nyc-master-electrical-exam-latest-update-2026-update-recent-exam-fully-solved-updated-2026-most-tested-2026-flas… 2/70
,7/10/26, 7:01 PM NYC Master Electrical Exam (Latest Update 2026) UPDATE!! (Recent exam) Fully solved & updated 2026 Most TESTED (2026 Fla…
Live parts of electrical equipment 50 volts
operating at ______volts or more she'll 4) by elevation of 8 feet or more above the floor or
be guarded against accidental other working surface
contact or approved enclosures or
by any of the following means
A fence shall not be less than 8 feet
______feet in height
One entrance to enclosures for 30 inches and 6.5 feet
electrical installations as described
in 110.31 not less than _______wide and
_________high shall be provided to give
access to the working space around
the electrical equipment
Network compartments shall have at Two
least ________means of access. Each
door she'll have an access that leads
to a legal exit.
Where rear access is required to 30 inches
work on deenergized parts on the
back of enclosed equipment a
minimum working space of
__________horizontally shall be provided
All non-current carrying metal parts 1000 feet
of electrical equipment and all metal
raceways and cable shall be solidly
grounded and bonded to all metal
pipes in rails at the portal and the
intervals not exceeding
_____________throughout the tunnel.
https://quizlet.com/1194117538/nyc-master-electrical-exam-latest-update-2026-update-recent-exam-fully-solved-updated-2026-most-tested-2026-flas… 3/70
, 7/10/26, 7:01 PM NYC Master Electrical Exam (Latest Update 2026) UPDATE!! (Recent exam) Fully solved & updated 2026 Most TESTED (2026 Fla…
Manhole workspace for cabling-A 3 feet
clear workspace not less than 2-1/2 feet
_______wide shall be provided were
cables are located on both sides and
not less than _______were cables are
only on one side.
Access to manhole dimensions. 26" x 22"
Rectangular access openings shall 26"
not be less than _______. Round access
openings in a manhole shall be not
less than ______inches in diameter
Manhole openings for personnel Protective barrier of fixed ladder
shall be located where they are not
directly above electrical equipment
or conductors in the enclosure.
Where this is not practiceable either
a ________or a _______shall be provided.
And insulated grounded conductor 6 awg
of _____or smaller shall be identified
by a continuous white or gray outer
finish or by three continuous white
stripes on other than green insulation
along its entire length.
Manhole covers shall be over 100 pounds
______pounds or otherwise designated
to require the use of tools to open.
https://quizlet.com/1194117538/nyc-master-electrical-exam-latest-update-2026-update-recent-exam-fully-solved-updated-2026-most-tested-2026-flas… 4/70
