Millwright Lubrication Exam Questions and
Answers with Verified Solutions | Latest
Updated 2026
Which of the following is not a C) To increase friction.
function of lubricating oil?
A) To carry away heat?
B) To carry away contaminants.
C) To increase friction.
D) To protect against corrosion.
Carb bearings can accommodate D).5
up
to ____ degrees angular
misalignment.
A) 4.5
B) 3.5
C) 2
D) 0.5
Dowels are seated _____ the bolts A) before
are
tightened to ensure accurate
alignment of each half of the
housing
bore.
A) before
B) after
C) either before or after
, When removing bearings from a A)push back
tapered shaft no puller is required
since there is a/an ____
component to
the hydraulic force due to the
taper.
A) push back
B) friction
C) lubricant
D) axial
The film under a reciprocating load A) smaller
is
very thin, strong and operates in
____
clearance than under a stationary
load.
A) a smaller
B) a larger
C) about the same
Which of the following best A) Can not be used in random order
describes a matched set bearing?
A) Can not be used in random
order
B) Can be installed back to back
or
face to face
C) It has a 30 or 32 degree contact
angle
D) It can handle reversing thrust
loads in either direction
E) It is designed for pure thrust
load
only
Answers with Verified Solutions | Latest
Updated 2026
Which of the following is not a C) To increase friction.
function of lubricating oil?
A) To carry away heat?
B) To carry away contaminants.
C) To increase friction.
D) To protect against corrosion.
Carb bearings can accommodate D).5
up
to ____ degrees angular
misalignment.
A) 4.5
B) 3.5
C) 2
D) 0.5
Dowels are seated _____ the bolts A) before
are
tightened to ensure accurate
alignment of each half of the
housing
bore.
A) before
B) after
C) either before or after
, When removing bearings from a A)push back
tapered shaft no puller is required
since there is a/an ____
component to
the hydraulic force due to the
taper.
A) push back
B) friction
C) lubricant
D) axial
The film under a reciprocating load A) smaller
is
very thin, strong and operates in
____
clearance than under a stationary
load.
A) a smaller
B) a larger
C) about the same
Which of the following best A) Can not be used in random order
describes a matched set bearing?
A) Can not be used in random
order
B) Can be installed back to back
or
face to face
C) It has a 30 or 32 degree contact
angle
D) It can handle reversing thrust
loads in either direction
E) It is designed for pure thrust
load
only
