IPC J-STD-001 J Section 1 Exam
Questions & Answers (Grade A+)
Defects SHALL be identified, documented, and dispositioned by the
Manufacturer based on the design, service and User requirements.
-
correct answer ✅[D1D2D3]
Hardware found to be produced using either materials or process
that do not conform to the requirements of this standard SHALL be
classified as defects and dispositioned. -
correct answer ✅[D1D2D3]
This disposition SHALL address the potential effect of the
nonconformance on functional capability of the hardware such as
reliability and design life (longevity). -
correct answer ✅[D1D2D3]
Specialized processes and/or technologies not specified herein
SHALL be performed in accordance with documented procedures
which are available for review. -
correct answer ✅[N1D2D3]
The external interconnect points, e.g., terminals, pins, SHALL meet
the solderability requirements of 4.1 Solderability. -
correct answer ✅[D1D2D3]
, IPC J-STD-001 J Section 1 Exam
Questions & Answers (Grade A+)
Unless the engineering documentation provides additional
instruction on broken or damaged strands, there SHALL NOT be any
broken or damaged strands for wires identified as being high
voltage/high current. -
correct answer ✅[D1D2D3]
Manufacturers of Class 3 products SHALL develop and implement a
documented process control system. -
correct answer ✅[N1N2D3]
A documented process control system, if established, SHALL define
process control and corrective action limits. -
correct answer ✅[N1D2D3]
Process control methodologies SHALL be used in the planning,
implementation and evaluation of the manufacturing processes
used to produce soldered electrical and electronic assemblies. -
correct answer ✅[N1D2D3]
When a decision or requirement is to use a documented process
control system, failure to implement process corrective action
and/or the use of continually ineffective corrective actions SHALL
Questions & Answers (Grade A+)
Defects SHALL be identified, documented, and dispositioned by the
Manufacturer based on the design, service and User requirements.
-
correct answer ✅[D1D2D3]
Hardware found to be produced using either materials or process
that do not conform to the requirements of this standard SHALL be
classified as defects and dispositioned. -
correct answer ✅[D1D2D3]
This disposition SHALL address the potential effect of the
nonconformance on functional capability of the hardware such as
reliability and design life (longevity). -
correct answer ✅[D1D2D3]
Specialized processes and/or technologies not specified herein
SHALL be performed in accordance with documented procedures
which are available for review. -
correct answer ✅[N1D2D3]
The external interconnect points, e.g., terminals, pins, SHALL meet
the solderability requirements of 4.1 Solderability. -
correct answer ✅[D1D2D3]
, IPC J-STD-001 J Section 1 Exam
Questions & Answers (Grade A+)
Unless the engineering documentation provides additional
instruction on broken or damaged strands, there SHALL NOT be any
broken or damaged strands for wires identified as being high
voltage/high current. -
correct answer ✅[D1D2D3]
Manufacturers of Class 3 products SHALL develop and implement a
documented process control system. -
correct answer ✅[N1N2D3]
A documented process control system, if established, SHALL define
process control and corrective action limits. -
correct answer ✅[N1D2D3]
Process control methodologies SHALL be used in the planning,
implementation and evaluation of the manufacturing processes
used to produce soldered electrical and electronic assemblies. -
correct answer ✅[N1D2D3]
When a decision or requirement is to use a documented process
control system, failure to implement process corrective action
and/or the use of continually ineffective corrective actions SHALL
