ICC Fire Inspector Exam Questions With
Correct Answers
(1 - 1) Stairways that are part of the means of egress for the exterior
| | | | | | | | | | | | | | |
provide a minimum clear width of (BLANK) between handrails? -
| | | | | | | | | |
CORRECT ANSWER✔✔-D. 48 inches ( IBC 1009.7.4)
| | | | | |
1-2 What is the minimum density allowable for foam plastic used as
| | | | | | | | | | | |
interior trim ? - CORRECT ANSWER✔✔-B. 20 Pounds per Cubic Foot (IBC
| | | | | | | | | | |
|2604.2.1)
1-3 Group B buildings having an occupant load of (BLANK) or more than
| | | | | | | | | | | | |
100 persons above or below the lowest level of exit discharge and for
| | | | | | | | | | | | |
buildings having an ambulatory care facility are required by the
| | | | | | | | | |
international fire code to have an approved fire safety and evacuation
| | | | | | | | | | |
plan prepared and maintained for this property. - CORRECT
| | | | | | | | |
ANSWER✔✔-C. 500 or more persons (IFC 403.3 Group B occupancy) | | | | | | | | |
1-4 In assemblies used for structural fire resistance and fire-resistance-
| | | | | | | | |
related construction, each portion of a building separated by one or
| | | | | | | | | | |
more fire walls that comply with the provisions of the fire wall section of
| | | | | | | | | | | | |
the code is to be considered (BLANK), and the extent and location of
| | | | | | | | | | | | | |
such fire walls must provide a complete separation. - CORRECT
| | | | | | | | | |
ANSWER✔✔-C. A Separate Building (IBC 706.1) | | | | |
, 1-5 In assemblies used for structural fire resistance and fire-resistance-
| | | | | | | | |
rated construction, through penetration are to be protected using
| | | | | | | | |
systems installed as (BLANK) in the approved fire-resistance-rated
| | | | | | | |
assembly. - CORRECT ANSWER✔✔-D. Tested (IBC 714.4.1.1)
| | | | | |
1-6 Exterior landings outside of egress door are permitted to have a
| | | | | | | | | | | |
slope which does not exceed (BLANK) *exceptions ignored* - CORRECT
| | | | | | | | | |
ANSWER✔✔-C. 0.25 Unit Vertical in 12 Units Horizontal. (IBC 1010.1.4)| | | | | | | | |
1-7 Any tower, spire, dome or cupola that exceeds 60 feet in height
| | | | | | | | | | | | |
above the highest point at which it comes in contact with the roof, or
| | | | | | | | | | | | | |
that exceeds 200 square feet in area at any horizontal section, or which
| | | | | | | | | | | | |
is intended to be used for any purpose other than a belfry or
| | | | | | | | | | | | |
architectural embellishment, must be entirely constructed of and
| | | | | | | |
supported by noncombustible materials and must be separated from
| | | | | | | | |
the building below by construction having a fire-resistance rating of not
| | | | | | | | | | |
less than (BLANK) hours. Rating. - CORRECT ANSWER✔✔-A. 1-1/2 hours
| | | | | | | | | |
(IBC 1511.51
|
1-8 what interior wall and ceiling class finish is required in sprinklered
| | | | | | | | | | | |
rooms and enclosed spaces of a Group A-4 Occupancy? - CORRECT
| | | | | | | | | | |
ANSWER✔✔-C. Class C Finishes (IBC table 803.13) | | | | | |
Correct Answers
(1 - 1) Stairways that are part of the means of egress for the exterior
| | | | | | | | | | | | | | |
provide a minimum clear width of (BLANK) between handrails? -
| | | | | | | | | |
CORRECT ANSWER✔✔-D. 48 inches ( IBC 1009.7.4)
| | | | | |
1-2 What is the minimum density allowable for foam plastic used as
| | | | | | | | | | | |
interior trim ? - CORRECT ANSWER✔✔-B. 20 Pounds per Cubic Foot (IBC
| | | | | | | | | | |
|2604.2.1)
1-3 Group B buildings having an occupant load of (BLANK) or more than
| | | | | | | | | | | | |
100 persons above or below the lowest level of exit discharge and for
| | | | | | | | | | | | |
buildings having an ambulatory care facility are required by the
| | | | | | | | | |
international fire code to have an approved fire safety and evacuation
| | | | | | | | | | |
plan prepared and maintained for this property. - CORRECT
| | | | | | | | |
ANSWER✔✔-C. 500 or more persons (IFC 403.3 Group B occupancy) | | | | | | | | |
1-4 In assemblies used for structural fire resistance and fire-resistance-
| | | | | | | | |
related construction, each portion of a building separated by one or
| | | | | | | | | | |
more fire walls that comply with the provisions of the fire wall section of
| | | | | | | | | | | | |
the code is to be considered (BLANK), and the extent and location of
| | | | | | | | | | | | | |
such fire walls must provide a complete separation. - CORRECT
| | | | | | | | | |
ANSWER✔✔-C. A Separate Building (IBC 706.1) | | | | |
, 1-5 In assemblies used for structural fire resistance and fire-resistance-
| | | | | | | | |
rated construction, through penetration are to be protected using
| | | | | | | | |
systems installed as (BLANK) in the approved fire-resistance-rated
| | | | | | | |
assembly. - CORRECT ANSWER✔✔-D. Tested (IBC 714.4.1.1)
| | | | | |
1-6 Exterior landings outside of egress door are permitted to have a
| | | | | | | | | | | |
slope which does not exceed (BLANK) *exceptions ignored* - CORRECT
| | | | | | | | | |
ANSWER✔✔-C. 0.25 Unit Vertical in 12 Units Horizontal. (IBC 1010.1.4)| | | | | | | | |
1-7 Any tower, spire, dome or cupola that exceeds 60 feet in height
| | | | | | | | | | | | |
above the highest point at which it comes in contact with the roof, or
| | | | | | | | | | | | | |
that exceeds 200 square feet in area at any horizontal section, or which
| | | | | | | | | | | | |
is intended to be used for any purpose other than a belfry or
| | | | | | | | | | | | |
architectural embellishment, must be entirely constructed of and
| | | | | | | |
supported by noncombustible materials and must be separated from
| | | | | | | | |
the building below by construction having a fire-resistance rating of not
| | | | | | | | | | |
less than (BLANK) hours. Rating. - CORRECT ANSWER✔✔-A. 1-1/2 hours
| | | | | | | | | |
(IBC 1511.51
|
1-8 what interior wall and ceiling class finish is required in sprinklered
| | | | | | | | | | | |
rooms and enclosed spaces of a Group A-4 Occupancy? - CORRECT
| | | | | | | | | | |
ANSWER✔✔-C. Class C Finishes (IBC table 803.13) | | | | | |
