Pipe Fitters Test ACTUAL UPDATED QUESTIONS AND CORRECT ANSWERS
Convert 1/4 into a decimal .25
Piping that is field-routed to a pump must be supported.. Independently
what is used when lighting a cutting torch? Striker
, Where is specific information needed to install piping Standards and Specifications
and associated items found?
Damage and broken tools should be Taken Out Of Service
What is the ID of 10" schedule 80 piping? 9 9/16
the Two Steps in making up threaded joints are the hand Wrench makeup
engagement and
Which action should be taken before a HYDRO STATIC Remove pressure relief valves
test is performed?
A 4-inch lateral riser is to be fabricated for a 6-inch pipe. 8
How many ordinate lines will be needed to lay out this
cut?
who is qualified to repair power tools? Competent Technician
Material placed in the bottom of the trench under the bedding
pipe to provide support is called?
Socket weld joints have a gap between the end of the Prevents weld cracking
pipe and the bottom of the socket. What is the purpose
of this gap?
Which of the following plastic pipes is NOT joined by a B) HDPE
solvent welding?
A) PVC
B) HDPE
C) CPVC
D) ABS
When are rupture disc installed into a pipeline? Before start-up of the system
Chain come-alongs are PRIMARILY designed for? Vertical lifting
Which of the following types of copper tubing has the K
thickest wall?
K , L , M , Acr ?
What is the MINIMUM grade of chain that nay be used 8
for rigging loads overhead?
At and above what normal pipe size is the O.D of the 14"
pipe the same as the normal size of the pipe?
Which type of field sketch has base lines that are 30 Isometric
degrees to the horizontal axis?
Convert 1/4 into a decimal .25
Piping that is field-routed to a pump must be supported.. Independently
what is used when lighting a cutting torch? Striker
, Where is specific information needed to install piping Standards and Specifications
and associated items found?
Damage and broken tools should be Taken Out Of Service
What is the ID of 10" schedule 80 piping? 9 9/16
the Two Steps in making up threaded joints are the hand Wrench makeup
engagement and
Which action should be taken before a HYDRO STATIC Remove pressure relief valves
test is performed?
A 4-inch lateral riser is to be fabricated for a 6-inch pipe. 8
How many ordinate lines will be needed to lay out this
cut?
who is qualified to repair power tools? Competent Technician
Material placed in the bottom of the trench under the bedding
pipe to provide support is called?
Socket weld joints have a gap between the end of the Prevents weld cracking
pipe and the bottom of the socket. What is the purpose
of this gap?
Which of the following plastic pipes is NOT joined by a B) HDPE
solvent welding?
A) PVC
B) HDPE
C) CPVC
D) ABS
When are rupture disc installed into a pipeline? Before start-up of the system
Chain come-alongs are PRIMARILY designed for? Vertical lifting
Which of the following types of copper tubing has the K
thickest wall?
K , L , M , Acr ?
What is the MINIMUM grade of chain that nay be used 8
for rigging loads overhead?
At and above what normal pipe size is the O.D of the 14"
pipe the same as the normal size of the pipe?
Which type of field sketch has base lines that are 30 Isometric
degrees to the horizontal axis?
