ICC Exam 66: Fire Inspector I With
Questions And Answers with rationals
latest update lated A+
Section 1: General Inspection Administration
(Administration and Enforcement)
1. What is the primary purpose of a fire inspection?
A. To issue building permits
B. To enforce fire and life safety codes
C. To design fire sprinkler systems
D. To perform structural engineering
Answer: B
Rationale: Fire inspections are conducted to ensure
compliance with adopted fire codes and to protect life and
property from fire hazards . This is a fundamental concept
tested on the exam to ensure candidates understand the
core mission of the fire inspector role .
2. Which authority typically grants fire protection permits
for hot-work operations?
A. Building Owner
,B. Local Fire Marshal
C. State Health Department
D. OSHA Inspector
Answer: B
Rationale: The local fire marshal, acting as the Authority
Having Jurisdiction (AHJ), issues permits for hot-work to
ensure fire safety controls are in place before operations
begin .
3. When reviewing an inspection report, which element
most directly demonstrates compliance with the required
egress illumination level?
A. Floor-plan sketch
B. Photometric calculations
C. Photocopy of fire alarm panel log
D. List of fire extinguisher locations
Answer: B
Rationale: Photometric calculations show that the measured
foot-candles meet the minimum illumination required for
exit paths during a power failure .
,4. Under the Board of Appeals process, a fire inspector's
decision can be appealed on the basis of:
A. Personal disagreement with the inspector
B. Misinterpretation of the applicable code
C. The inspector's lack of a college degree
D. The building's age
Answer: B
Rationale: Appeals are permitted when the decision is
believed to be contrary to the code or regulations . This is a
key administrative/legal concept tested in the General
Administration section.
5. An inspector must be cautious when using a pre-printed
checklist to ensure:
A. It is brought to each inspection
B. It matches the occupancy type
C. Overlooked conditions not on the list are still identified
D. All items on the list are covered
Answer: C
Rationale: A checklist is a valuable tool and serves as a
record, but an inspector must be cautious not to overlook
, conditions or violations that are present but may not be
included on the checklist .
Section 2: General Provisions for Fire Safety (Means of
Egress, Construction Types, Fire Protection Systems)
6. What is the minimum required width for an exit access
in most occupancies (serving an occupant load up to 50)?
A. 28 inches
B. 32 inches
C. 36 inches
D. 44 inches
Answer: C
Rationale: The IBC requires a minimum egress width of 36
inches for an occupant load up to 50 persons, regardless of
construction type . This is a foundational egress
measurement.
7. A fire-resistance-rated wall having protected openings,
which restricts the spread of fire and extends continuously
from foundation to or through the roof, with sufficient
structural stability to allow collapse on either side without
collapse of the wall, is a:
Questions And Answers with rationals
latest update lated A+
Section 1: General Inspection Administration
(Administration and Enforcement)
1. What is the primary purpose of a fire inspection?
A. To issue building permits
B. To enforce fire and life safety codes
C. To design fire sprinkler systems
D. To perform structural engineering
Answer: B
Rationale: Fire inspections are conducted to ensure
compliance with adopted fire codes and to protect life and
property from fire hazards . This is a fundamental concept
tested on the exam to ensure candidates understand the
core mission of the fire inspector role .
2. Which authority typically grants fire protection permits
for hot-work operations?
A. Building Owner
,B. Local Fire Marshal
C. State Health Department
D. OSHA Inspector
Answer: B
Rationale: The local fire marshal, acting as the Authority
Having Jurisdiction (AHJ), issues permits for hot-work to
ensure fire safety controls are in place before operations
begin .
3. When reviewing an inspection report, which element
most directly demonstrates compliance with the required
egress illumination level?
A. Floor-plan sketch
B. Photometric calculations
C. Photocopy of fire alarm panel log
D. List of fire extinguisher locations
Answer: B
Rationale: Photometric calculations show that the measured
foot-candles meet the minimum illumination required for
exit paths during a power failure .
,4. Under the Board of Appeals process, a fire inspector's
decision can be appealed on the basis of:
A. Personal disagreement with the inspector
B. Misinterpretation of the applicable code
C. The inspector's lack of a college degree
D. The building's age
Answer: B
Rationale: Appeals are permitted when the decision is
believed to be contrary to the code or regulations . This is a
key administrative/legal concept tested in the General
Administration section.
5. An inspector must be cautious when using a pre-printed
checklist to ensure:
A. It is brought to each inspection
B. It matches the occupancy type
C. Overlooked conditions not on the list are still identified
D. All items on the list are covered
Answer: C
Rationale: A checklist is a valuable tool and serves as a
record, but an inspector must be cautious not to overlook
, conditions or violations that are present but may not be
included on the checklist .
Section 2: General Provisions for Fire Safety (Means of
Egress, Construction Types, Fire Protection Systems)
6. What is the minimum required width for an exit access
in most occupancies (serving an occupant load up to 50)?
A. 28 inches
B. 32 inches
C. 36 inches
D. 44 inches
Answer: C
Rationale: The IBC requires a minimum egress width of 36
inches for an occupant load up to 50 persons, regardless of
construction type . This is a foundational egress
measurement.
7. A fire-resistance-rated wall having protected openings,
which restricts the spread of fire and extends continuously
from foundation to or through the roof, with sufficient
structural stability to allow collapse on either side without
collapse of the wall, is a:
