ASE A3 Exam Questions & Answers | 100%
Verified solutions (2026) UPDATE |2026!! STUDY
GUIDE EXAM
Save
Practice questions for this set
Learn 1 /7 Study with Learn
Increase the thickness of both shims.
Choose an answer
Noise: In gear, clutch disengaged On a shim adjustable system, how
1 2
(pedal to floor) do you increase pre-load?
What is used to check the
Can a bad speed sensor affect shift
3 4 clearance between the shift fork
pattern?
and the synchronizer sleeve?
Don't know?
Terms in this set (65)
, Noise: In gear, clutch disengaged Pilot bushing or bearing
(pedal to floor)
Noise: Neutral, clutch disengaged Release bearing
(pedal to floor)
Noise: Neutral, clutch engaged Input shaft bearing
(pedal up)
Binding U-Joint will damage?? Extension housing bushing and seal
What is used to check the clearance A feeler guage
between the shift fork and the
synchronizer sleeve?
Warped pressure plates... ... should be replaced
Ring and pinion gears... ...should be replaced as a set
What tool is used to measure ring A dial guage
gear runout?
How many times can a collapsible Once, and must be replaced if over tightened.
sleeve be tightened?
What tool is used to check pinion Inch pound torque wrench
bearing preload?
How much vacuum is required to 15hg
operate a transfer case?
What type of bearings require Tapered roller bearings
preload?
Verified solutions (2026) UPDATE |2026!! STUDY
GUIDE EXAM
Save
Practice questions for this set
Learn 1 /7 Study with Learn
Increase the thickness of both shims.
Choose an answer
Noise: In gear, clutch disengaged On a shim adjustable system, how
1 2
(pedal to floor) do you increase pre-load?
What is used to check the
Can a bad speed sensor affect shift
3 4 clearance between the shift fork
pattern?
and the synchronizer sleeve?
Don't know?
Terms in this set (65)
, Noise: In gear, clutch disengaged Pilot bushing or bearing
(pedal to floor)
Noise: Neutral, clutch disengaged Release bearing
(pedal to floor)
Noise: Neutral, clutch engaged Input shaft bearing
(pedal up)
Binding U-Joint will damage?? Extension housing bushing and seal
What is used to check the clearance A feeler guage
between the shift fork and the
synchronizer sleeve?
Warped pressure plates... ... should be replaced
Ring and pinion gears... ...should be replaced as a set
What tool is used to measure ring A dial guage
gear runout?
How many times can a collapsible Once, and must be replaced if over tightened.
sleeve be tightened?
What tool is used to check pinion Inch pound torque wrench
bearing preload?
How much vacuum is required to 15hg
operate a transfer case?
What type of bearings require Tapered roller bearings
preload?