ICC VAPOR RECOVERY 2 60 COMPETENCY
REVIEW 2026 MOCK TEST COMPLETE KEY
INSIGHTS
◉ Organization that certifies vapor recovery systems. Answer: CARB
or ARB
◉ According to RP 500, a level II technician may NOT inspect this
part. Answer: Replace VP 1000 Healy Pump
◉ where hanging hardware repairs must be tracked. Answer: GDF
maintenance log
◉ approved sealant when assembling a Phil-Tite Drop Tube. Answer:
JB-Kwik
◉ Material direct bury OPW container sleeve shall be made of.
Answer: Stainless steel
◉ What P/V vent cap shall be tightened to. Answer: 20-50 ft lbs
, ◉ From dispenser to manifold - 2" diameter vapor piping ( 2" ID)
and From manifold to tank - 3" diameter vapor piping (3" ID)
Answer: Vapor piping
◉ What is the maximum run for vapor piping? Answer: No
maximum run
◉ How you know a nozzle spout is bad. Answer: 'BAD O-rinqs
◉ According to PEI RP 300, on a balance Stage II vapor recovery
system nozzle, Vapors typically flow in what direction of the coaxial
hose? Answer: The outside pathway
◉ What is the maximum allowable number of P/V caps allowed on a
UST fuel system? Answer: One
◉ On a Healy Air Separator, there are four Ball Valves, the following
shall be observed? Answer: One valve shall remain open on top
◉ The Pressure settings for the UST Vent Cap is. Answer: .0+-
0.5inches H2O Negative Pressure 1,0+-2.0 inches H2O Positive
Pressure
REVIEW 2026 MOCK TEST COMPLETE KEY
INSIGHTS
◉ Organization that certifies vapor recovery systems. Answer: CARB
or ARB
◉ According to RP 500, a level II technician may NOT inspect this
part. Answer: Replace VP 1000 Healy Pump
◉ where hanging hardware repairs must be tracked. Answer: GDF
maintenance log
◉ approved sealant when assembling a Phil-Tite Drop Tube. Answer:
JB-Kwik
◉ Material direct bury OPW container sleeve shall be made of.
Answer: Stainless steel
◉ What P/V vent cap shall be tightened to. Answer: 20-50 ft lbs
, ◉ From dispenser to manifold - 2" diameter vapor piping ( 2" ID)
and From manifold to tank - 3" diameter vapor piping (3" ID)
Answer: Vapor piping
◉ What is the maximum run for vapor piping? Answer: No
maximum run
◉ How you know a nozzle spout is bad. Answer: 'BAD O-rinqs
◉ According to PEI RP 300, on a balance Stage II vapor recovery
system nozzle, Vapors typically flow in what direction of the coaxial
hose? Answer: The outside pathway
◉ What is the maximum allowable number of P/V caps allowed on a
UST fuel system? Answer: One
◉ On a Healy Air Separator, there are four Ball Valves, the following
shall be observed? Answer: One valve shall remain open on top
◉ The Pressure settings for the UST Vent Cap is. Answer: .0+-
0.5inches H2O Negative Pressure 1,0+-2.0 inches H2O Positive
Pressure
