BMW MEMBERS 2O26 REAL / ACTUAL
EXAM QUESTIONS AND CORRECT
VERIFIED ANSWERS. 100%. WITH OVER
1000 ITEMS.
- QUESTION- ACP - ANSWER -AUDIO CONTROL PANEL
- QUESTION- ACSM-MRS - ANSWER -CRASH SAFETY MODULE- MULTIPLE RESTRAINT SYSTEM
- QUESTION- What causes brake pulsation? - ANSWER -Variation thickness of brake rotor
- QUESTION- A wheel bearing can cause a DSC fault. True or False? - ANSWER -True
- QUESTION- 3 wheel shows 24 miles and 1 is 23, what can be the cause? - ANSWER -Bad wheel bearing
- QUESTION- In a parallel circuit it shows three bulbs that aren't operating. What can be the cause ? -
ANSWER -Open from Y TO Z
,- QUESTION- An XDrive vehicle equipped with a transfer case makes a clunking noise during accelerating
and braking. What could be the cause? - ANSWER -Loose Chain
- QUESTION- A vehicle comes in with a faulty differential. The fluid is overfilled and creamy, what could
be the cause? - ANSWER -Water in the fluid
- QUESTION- A vehicle comes in with a concern of a clunking sound from the rear during a braking and
accelerating. What is the most likely cause? - ANSWER -Thrust Arm
- QUESTION- A circuit shows a radio that is inoperative on the power outlet side. What could be the
cause? - ANSWER -Bad Fuse
- QUESTION- A circuit shows the horn is inoperative. What could be the cause? - ANSWER -High
resistance on the clock spring
- QUESTION- A vehicle has an overheated left front rotor during driving. What could be the cause? -
ANSWER -Seized front left caliper piston
- QUESTION- DCS equipped vehicles use a system to choke or drop the RPM in the engine. True or false?
- ANSWER -True
- QUESTION- On a DSC equipped vehicle, Technician A says it receives inputs from the steering angle
sensor. Technician B says it receives inputs from the brake switch. - ANSWER -Both
- QUESTION- DSC equipped vehicle deactivates traction when it's cold outside. True or false? - ANSWER
-False
,- QUESTION- 0.1 ohms is shown at the injectors. What could be the cause? - ANSWER -Short injector
- QUESTION- A vehicle with a spongy pedal with leaking fluid slowly sinks to the floor. What could be the
cause? - ANSWER -Primary seal is bad
- QUESTION- A vehicle comes in with a concert of stiff pedal when pressing rapidly. What could be the
cause? - ANSWER -Check valve
- QUESTION- When you press the brake pedal in and it releases the brake booster hard. What could be
the cause? - ANSWER -Vent port
- QUESTION- A diagram shows 50 on one end and 110 on the other with different alignment angles.
What would it cause? - ANSWER -Pulling to the left
- QUESTION- Does a vehicle always pull to the most positive caster and negative camber. True or false? -
ANSWER -False
- QUESTION- A bent strut mount can affect camber angle/alignment. True or false? - ANSWER -True
- QUESTION- A vehicle comes in with a engine over heating concern during load but goes away at idle.
What could be the cause? - ANSWER -Restriction in coolant radiator hose.
- QUESTION- what is used to measure key off battery drain ? - ANSWER -Amp clamp
, - QUESTION- Vanos solenoid can cause a no start. True or false? - ANSWER -False
- QUESTION- What can be the cause of clunking noise in front of the car? - ANSWER -Worn or Damaged
stabilizer link
- QUESTION- Tech a says over torqued ball joint nut can cause damage to the ball joint stud , Tech B says
that out of round knuckle hole can cause damage to ball joint stud - ANSWER -Both
- QUESTION- Bucking on freeway concerns can be caused by? - ANSWER -Fuel delivery
- QUESTION- steering wheel Jerks every half of a turn. What can be the cause? - ANSWER -Faulty
steering column U Joint
- QUESTION- Cooling system overheats after servicing. What can be the cause - ANSWER -Air in the
system
- QUESTION- infinite resistance on wheel speed sensor and
constant 12v by wheel speed means that they are - ANSWER -Faulty
- QUESTION- AC circuit blows fuse right away. What can be the cause? - ANSWER -Shorted AC clutch
- QUESTION- Tech A says DSC uses steering wheel angle as input, Tech b says DSC uses brake light switch
as input - ANSWER -Both
EXAM QUESTIONS AND CORRECT
VERIFIED ANSWERS. 100%. WITH OVER
1000 ITEMS.
- QUESTION- ACP - ANSWER -AUDIO CONTROL PANEL
- QUESTION- ACSM-MRS - ANSWER -CRASH SAFETY MODULE- MULTIPLE RESTRAINT SYSTEM
- QUESTION- What causes brake pulsation? - ANSWER -Variation thickness of brake rotor
- QUESTION- A wheel bearing can cause a DSC fault. True or False? - ANSWER -True
- QUESTION- 3 wheel shows 24 miles and 1 is 23, what can be the cause? - ANSWER -Bad wheel bearing
- QUESTION- In a parallel circuit it shows three bulbs that aren't operating. What can be the cause ? -
ANSWER -Open from Y TO Z
,- QUESTION- An XDrive vehicle equipped with a transfer case makes a clunking noise during accelerating
and braking. What could be the cause? - ANSWER -Loose Chain
- QUESTION- A vehicle comes in with a faulty differential. The fluid is overfilled and creamy, what could
be the cause? - ANSWER -Water in the fluid
- QUESTION- A vehicle comes in with a concern of a clunking sound from the rear during a braking and
accelerating. What is the most likely cause? - ANSWER -Thrust Arm
- QUESTION- A circuit shows a radio that is inoperative on the power outlet side. What could be the
cause? - ANSWER -Bad Fuse
- QUESTION- A circuit shows the horn is inoperative. What could be the cause? - ANSWER -High
resistance on the clock spring
- QUESTION- A vehicle has an overheated left front rotor during driving. What could be the cause? -
ANSWER -Seized front left caliper piston
- QUESTION- DCS equipped vehicles use a system to choke or drop the RPM in the engine. True or false?
- ANSWER -True
- QUESTION- On a DSC equipped vehicle, Technician A says it receives inputs from the steering angle
sensor. Technician B says it receives inputs from the brake switch. - ANSWER -Both
- QUESTION- DSC equipped vehicle deactivates traction when it's cold outside. True or false? - ANSWER
-False
,- QUESTION- 0.1 ohms is shown at the injectors. What could be the cause? - ANSWER -Short injector
- QUESTION- A vehicle with a spongy pedal with leaking fluid slowly sinks to the floor. What could be the
cause? - ANSWER -Primary seal is bad
- QUESTION- A vehicle comes in with a concert of stiff pedal when pressing rapidly. What could be the
cause? - ANSWER -Check valve
- QUESTION- When you press the brake pedal in and it releases the brake booster hard. What could be
the cause? - ANSWER -Vent port
- QUESTION- A diagram shows 50 on one end and 110 on the other with different alignment angles.
What would it cause? - ANSWER -Pulling to the left
- QUESTION- Does a vehicle always pull to the most positive caster and negative camber. True or false? -
ANSWER -False
- QUESTION- A bent strut mount can affect camber angle/alignment. True or false? - ANSWER -True
- QUESTION- A vehicle comes in with a engine over heating concern during load but goes away at idle.
What could be the cause? - ANSWER -Restriction in coolant radiator hose.
- QUESTION- what is used to measure key off battery drain ? - ANSWER -Amp clamp
, - QUESTION- Vanos solenoid can cause a no start. True or false? - ANSWER -False
- QUESTION- What can be the cause of clunking noise in front of the car? - ANSWER -Worn or Damaged
stabilizer link
- QUESTION- Tech a says over torqued ball joint nut can cause damage to the ball joint stud , Tech B says
that out of round knuckle hole can cause damage to ball joint stud - ANSWER -Both
- QUESTION- Bucking on freeway concerns can be caused by? - ANSWER -Fuel delivery
- QUESTION- steering wheel Jerks every half of a turn. What can be the cause? - ANSWER -Faulty
steering column U Joint
- QUESTION- Cooling system overheats after servicing. What can be the cause - ANSWER -Air in the
system
- QUESTION- infinite resistance on wheel speed sensor and
constant 12v by wheel speed means that they are - ANSWER -Faulty
- QUESTION- AC circuit blows fuse right away. What can be the cause? - ANSWER -Shorted AC clutch
- QUESTION- Tech A says DSC uses steering wheel angle as input, Tech b says DSC uses brake light switch
as input - ANSWER -Both
