MA Hoisting License 1B Exam Questions and Answers||A+ Solution guide(Verified)

MA Hoisting License 1B Exam Questions and Answers||A+ Solution guide(Verified) What is the most important single factor to the safe operation of the forklifts? - Answer- THE OPERATOR Many accidents happen because the operator does which of the following? - Answer- a) uses a forklift with a known defect b) travels an unsafe route c) carries unsafe loads d) uses unsafe operating techniques When is it safe to operate the forklift from a place other than the operator's seat? - Answer- NEVER Workers and bystanders within the danger area of the forklift should be considered the responsibility of? - Answer- THE OPERATOR Which of the following are essential for safe operation? - Answer- a) smooth starts b) smooth stops c) smooth turns The operator "feathers" the controls when he wants to? - Answer- MOVE THE LOAD SLOWLY If you find a fault or suspect an unsafe condition while inspecting or operating a forklift you should? - Answer- TELL YOUR SUPERVISOR If bystanders or a fellow worker are in danger from a raised load, you should? - Answer- SOUND YOUR HORN OR ASK THEM TO MOVE Which of the following affect forklift safety? - Answer- a) Leverage b) Center of gravity c) Momentum The pivot point of a forklift is? - Answer- THE FRONT AXLE The teeter totter is a simple example of? - Answer- LEVERAGE Safe load limits for a particular forklift ... - Answer- SHOULD NEVER BE EXCEEDED When a forklift picks up a load on the forks... - Answer- THE CENTER OF GRAVITY OF THE FORKLIFT MOVES FORWARD Forward tipping will occur unless the forklift's center of gravity is? - Answer- On The Opposite Side Of The Front Axle Momentum is a force created by? - Answer- a) Starting b) Stopping c) Turning Which of the following has or have an Effect on the amount of stability a forklift has? - Answer- a) Weight distribution b) Axle length c) Wheel base As the load of a forklift is raised, which of the following dangers increase? - Answer- a) Tipping b) Loss of steering c) The effects of momentum What force can cause a loaded forklift to tip forward when brakes are applied? - Answer- MOMENTUM When the forklift's center of gravity goes beyond the stability area? - Answer- THE FORKLIFT WILL TIP OVER True or False...Because the forklifts are designed with the forks in front it is not possible for it to tip backwards. - Answer- FALSE The type of forklift which is designed primarily to lift a load straight up with a limited amount of tilt movement forward is the? - Answer- MAST FORKLIFT Which of a forklift's four wheel steering capabilities should be used at high speeds or on Highways? - Answer- TWO-WHEEL STEERING, FRONT WHEELS FIXED STRAIGHT AHEAD, REAR WHEELS USED FOR STEERING Using a short turning radius when traveling at high speeds can cause overturning due to? - Answer- THE FORCES OF MOMENTUM When is it permissible to carry riders while you are operating a forklift? - Answer- NEVER If a forklift tips forward ... - Answer- STEERING CONTROL IS LOST When traveling up or down a ramp, you can place more traction on the front drive wheels of an unloaded forklift if the forks are? - Answer- KEPT POINTING DOWNHILL Rear-wheel steering used by many forklifts? - Answer- a) Cause both ends of the forklift to swing around when turned b) Can cause the load to fall off the forks if the turn is made too fast c) Causes them to act differently from cars, which have front wheel steering Do not start a forklift unless. - Answer- a) The controls are in neutral b) The hand brake is set c) You are sitting in the operator's seat When may reverse gears be used to slow or stop a forklift traveling forward? - Answer- NEVER What things determine how fast a hydraulic system moves? - Answer- a) The distance the controls are moved d) The engine speed Jerky movements can be avoided if the operator. - Answer- FEATHERS THE CONTROLS If the hydraulic system develops a leak during operation, you should. - Answer- a) Lower the load b) Shut off the engine c) Notify the supervisor Job site conditions are? - Answer- IMPORTANT SINCE THEY DETERMINE THE SAFE SPEED AT WHICH A FORKLIFT CAN OPERATE If the load being carried obstructs vision, the operator should? - Answer- DRIVE IN REVERSE When crossing railroad tracks or other similar rough sections with a loaded forklift you should? - Answer- CROSS THEM DIAGONALLY