CFI Written test Questions and Correct
Answers Verified Answers
What is the maximum distance from an airport that an aircraft
engaged in training operations may be operated without an
emergency locator transmitter
50 nm
The point where Vx and Vy meet is called the
Absolute ceiling
(there is no excess of power/thrust and only one speed will maintain
level flight)
What are the visibility and cloud clearance requirements at an airport
in Class G airspace when conducting takeoffs and landings at night?
1 SM visibility and clear of clouds remaining within 1/2 mile of the
airport
How does the wake turbulence vortex circulate around each wingtip?
Outward, upward, and around each tip.
What subjects must be covered on the presolo knowledge test?
Applicable regulations, flight characteristics, and operational limitations
of make and model aircraft to be flown.
If an accelerated stall occurs in a steep turn, how will the aircraft
respond?
,In a slip, the high wing stalls first; in a skid, the low wing stalls first; in
coordinated flight, both wings stall at the same time.
A flight instructor applicant must demonstrate spins in an airplane or
glider when
being retested for deficiencies in instructional proficiency on stall
awareness or spins demonstrated during an initial test
What class medical certificate, if any, is required for a person adding a
rating to a pilot certificate?
third class
In a twin-engine airplane, the single-engine service ceiling is the
maximum altitude at which the aircraft will no longer maintain a
50 feet per minute climb
What is the significance of the blue radial line on the airspeed
indicator of a light multi engine airplane and when is it to be used?
It indicates the speed which will provide the maximum altitude gain in a
given time when one engine is inoperative and should be used for climb
and final approach during engine-out operations.
If operating within 1/2 mile of the runway during night hours, you
may operate an aircraft in class G airspace if the visibility is greater
than
1 SM (if vis is less than 3 SM but no less than 1 SM, if operating in the
traffic pattern with 1/2 mi. of runway and remain clear of clouds)
Certain flight training is required for the issuance of a certificate. If
that instruction is in a helicopter or multiengine airplane, the
instructor is required, in part, to have
, at least 5 hours of experience as pilot in command in the make and
model of aircraft involved.
Authority for approval of a minimum equipment list (MEL) must be
obtained from the
FAA district office
Excessively high engine temperatures will
cause loss of power, excessive oil consumption, and possible
permanent internal engine damage.
What indications should you observe on the turn-and-slip during taxi?
The ball moved freely opposite the turn, and the needle deflects in the
direction of the turn.
When operating an aircraft with a constant speed propeller, which
procedure places the least stress on cylinder components?
When power settings are being decreased, reduce manifold pressure
before RPM.
Which condition causes Vmc to be the highest?
CG is at the most rearward allowable position.
On a multiengine airplane with engines which rotate clockwise, the
critical engine is the
left engine, because the right engine center of thrust is farther away
from the centerline of the fuselage.
The minimum pilot-in-command time requirement for a flight
instructor with multiengine privileges to give flight training to a
trainer for a multi-engine rating is
Answers Verified Answers
What is the maximum distance from an airport that an aircraft
engaged in training operations may be operated without an
emergency locator transmitter
50 nm
The point where Vx and Vy meet is called the
Absolute ceiling
(there is no excess of power/thrust and only one speed will maintain
level flight)
What are the visibility and cloud clearance requirements at an airport
in Class G airspace when conducting takeoffs and landings at night?
1 SM visibility and clear of clouds remaining within 1/2 mile of the
airport
How does the wake turbulence vortex circulate around each wingtip?
Outward, upward, and around each tip.
What subjects must be covered on the presolo knowledge test?
Applicable regulations, flight characteristics, and operational limitations
of make and model aircraft to be flown.
If an accelerated stall occurs in a steep turn, how will the aircraft
respond?
,In a slip, the high wing stalls first; in a skid, the low wing stalls first; in
coordinated flight, both wings stall at the same time.
A flight instructor applicant must demonstrate spins in an airplane or
glider when
being retested for deficiencies in instructional proficiency on stall
awareness or spins demonstrated during an initial test
What class medical certificate, if any, is required for a person adding a
rating to a pilot certificate?
third class
In a twin-engine airplane, the single-engine service ceiling is the
maximum altitude at which the aircraft will no longer maintain a
50 feet per minute climb
What is the significance of the blue radial line on the airspeed
indicator of a light multi engine airplane and when is it to be used?
It indicates the speed which will provide the maximum altitude gain in a
given time when one engine is inoperative and should be used for climb
and final approach during engine-out operations.
If operating within 1/2 mile of the runway during night hours, you
may operate an aircraft in class G airspace if the visibility is greater
than
1 SM (if vis is less than 3 SM but no less than 1 SM, if operating in the
traffic pattern with 1/2 mi. of runway and remain clear of clouds)
Certain flight training is required for the issuance of a certificate. If
that instruction is in a helicopter or multiengine airplane, the
instructor is required, in part, to have
, at least 5 hours of experience as pilot in command in the make and
model of aircraft involved.
Authority for approval of a minimum equipment list (MEL) must be
obtained from the
FAA district office
Excessively high engine temperatures will
cause loss of power, excessive oil consumption, and possible
permanent internal engine damage.
What indications should you observe on the turn-and-slip during taxi?
The ball moved freely opposite the turn, and the needle deflects in the
direction of the turn.
When operating an aircraft with a constant speed propeller, which
procedure places the least stress on cylinder components?
When power settings are being decreased, reduce manifold pressure
before RPM.
Which condition causes Vmc to be the highest?
CG is at the most rearward allowable position.
On a multiengine airplane with engines which rotate clockwise, the
critical engine is the
left engine, because the right engine center of thrust is farther away
from the centerline of the fuselage.
The minimum pilot-in-command time requirement for a flight
instructor with multiengine privileges to give flight training to a
trainer for a multi-engine rating is
