Written by students who passed Immediately available after payment Read online or as PDF Wrong document? Swap it for free 4.6 TrustPilot
logo-home
Document preview thumbnail
Preview 4 out of 39 pages
Exam (elaborations)

Apprentice Lineman General Knowledge Actual questions and answers with verified solutions| latest version test 2026.

Document preview thumbnail
Preview 4 out of 39 pages

Apprentice Lineman General Knowledge Actual questions and answers with verified solutions| latest version test 2026.

Content preview

Apprentice Lineman General Knowledge Actual
questions and answers with verified solutions| latest
version test 2026.



What year was the IBEW formed, and who was its President?
- ANSWER: 1890, Henry Miller



What should be checked for when examining as injured person? -
ANSWER: 1. Breathing

2. Pulse
3. Head Injury
4. Paralysis on one side of the face
5. Laryngectomee
6. Stains and burns on or around mouth


What is shock? - ANSWER: A depressed state of all body functions due to
failure of the circulatory system.


What are some signs of shock? - ANSWER: 1. Increased shallow
breathing
2. Cold clammy skin
3. Low body temperature


How should shock be treated? - ANSWER: 1. Maintain normal body
temperature
2. Ensure adequate oxygen supply
3. Keep warm

1|Page

,4. Control bleeding if necessary lie down with head lower than feet
5. Do not move unless necessary


What are ways to control bleeding? - ANSWER: Direct pressure on
pressure point and in extreme cases tourniquet.


What is artificial respiration? - ANSWER: The forcing of air into the lungs
of one who cannot breathe for himself.


How deep should a gain be cut? - ANSWER: 1/2"


Poles set on curves, corners, and strain points should be set __________
inches deeper. - ANSWER: 6


If a pole is set near an energized line what precautions should be
taken? - ANSWER: 1. Cover with protective equipment
2. Feeder holds
3. Rubber gloves


Wood poles are classified by their: - ANSWER: 1. Height
2. Top circumference
3. Circumference 6' from the bottom of the pole


The denominator of an improper fraction is __________ than the
numerator. - ANSWER: smaller


What materials do electrons travel freely through? - ANSWER: conductor



2|Page

,If few electrons travel freely through a material, that material is said to
be an _________. - ANSWER: insulator


Is there such a thing as a perfect insulator? - ANSWER: no


The opposition to current flow through a material is called? - ANSWER:
resistance


What is the unit of measurement of resistance? - ANSWER: Ohm


What is the resistance of 1000 feet of #10 copper? - ANSWER: 1 Ohm


What is electric current? - ANSWER: The definite drift of electrons from a
point of negative potential to a point of positive potential.


The unit of measurement of electromotive force is the: - ANSWER: Volt


The unit of current flow is: - ANSWER: Ampere


In a circuit the current is __________ proportional to the voltage and
__________ proportional to the resistance. - ANSWER: directly, inversely


The __________ at which work is done is power. The formula for this is: -
ANSWER: rate, Power = Work ÷ Time



One joule of work done in one second of time is one __________ of
electrical work. - ANSWER: Watt




3|Page

, The unit of electrical work is the __________ ? - ANSWER: Joule


The unit of electrical power is the __________ ? - ANSWER: Watt


__________ is the unit of measurement of work for mechanical power. -
ANSWER: Horsepower



What is the most common cause for lost power? - ANSWER: heat


How many watts are in one horsepower? - ANSWER: 746


One watt equals __________ horsepower? - ANSWER: .00134


What is a watts definition? - ANSWER: The power used when one amp
flows with one volt.


What is the speed of light? - ANSWER: 186,000 miles per second


What NECA district covers outside work exclusively? - ANSWER: Tenth
District


What is a guy? - ANSWER: A brace or cable fastened to strengthen a pole
and to keep it in position.


Aluminum has what conductivity, tensile strength, and weight of
copper? - ANSWER: 60%, 45%, 33%


One mill is equal to __________ of an inch? - ANSWER: 1/1000

4|Page

Document information

Uploaded on
February 23, 2026
Number of pages
39
Written in
2025/2026
Type
Exam (elaborations)
Contains
Questions & answers
$21.49

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
Sold
45
Followers
3
Items
4594
Last sold
4 days ago


Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions