FIRE INSPECTOR II LATEST EOC EXAMS QUESTIONS AND
ANSWERS MARKED A+
✔✔Complaints about how problems are made within the inspection process as a whole
can be addressed by? - ✔✔Creating a new or revising an existing SOP
✔✔Minimum vertical clearance for a fire lane? - ✔✔13'6"
✔✔Evacuation routes should have - ✔✔A primary and secondary route
✔✔Special amusement buildings should be classified as? - ✔✔Assembly occupancies
✔✔A mixed use occupancy consist of more than one different occupancy under one
roof that? - ✔✔Is not separated by a fire resistance rated occupancy separation
✔✔When two buildings are separated by a fire wall they are considered to be what? -
✔✔Separate buildings
✔✔The minimum Corridor with is determined by - ✔✔The number of people in the type
of occupancy
✔✔The maximum height for doorway threshold - ✔✔Half inch
✔✔Supports for tanks holding more than 500 gallons of dipping and coating flammable
liquids must have a fire rating of at least? - ✔✔A fire rating of one hour
✔✔In a cooking exhaust system the filter will be found in the? - ✔✔Type one hood
✔✔NFPA 495 - ✔✔Explosive Materials Code
✔✔Enclosed processing areas handling or using flammable liquids must be ventilated
at a rate sufficient to maintain the concentration of vapors with in the area at or below
what percentage - ✔✔Below 25%
✔✔The maximum pressure allowed for an atmospheric think storing flammable and
combustible liquids is? - ✔✔.5 psi
✔✔Two ways to increase the threshold quantity for gases or fluids - ✔✔Gas cabinets
and exhausted enclosures
✔✔Two ways to determine the fire load of a building - ✔✔1. Divide the total pounds of
combustible material by the area square footage
2. Use the classification system for fire loads developed by NIST
, ✔✔NFPA 204 - ✔✔Standard for smoke and heat venting
✔✔The standard that provides testing requirements for fire protection systems is what?
- ✔✔UFC 3-601-02
✔✔The type of fire protection system required for most areas with hazardous materials
is a - ✔✔Dry chemical system
✔✔Regardless of the weight of a fire extinguisher, the distance between the bottom of
the extinguisher in the floor should never be less than what distance? - ✔✔Should
never be less than 4 inches
✔✔How often should a 12 year hydrostatic test fire extinguisher be emptied and
subjected to maintenance procedures - ✔✔Every six years
✔✔In a dipping and coating area, the ventilation system must contain vapors to within?
- ✔✔5 feet of the source
✔✔Common hazards associated with HVAC equipment - ✔✔Clogged filters
Improperly adjusted fan belt drives
Combustible lint or debris near burners
✔✔NFPA 1031 - ✔✔Standard for Professional Qualifications for Fire Inspector and Plan
Examiner
✔✔In a sprinkler system, water is distributed directly to branch lines by? - ✔✔Cross
mains
✔✔Who provides contact and logistical information on the plans review application? -
✔✔The applicant for the plans review
✔✔FM-200 - ✔✔Clean agent
✔✔When on-scene to investigate a complaint: - ✔✔1. Bring facility folder
2. take detailed notes
3. ensure correction is initiated before leaving
4. if situation requires work order, ensure the work order is completed.
✔✔NFPA technical committee - ✔✔share information for a recommendation, comment
or proposal for code modification through mail, fax, or electronic format.
ANSWERS MARKED A+
✔✔Complaints about how problems are made within the inspection process as a whole
can be addressed by? - ✔✔Creating a new or revising an existing SOP
✔✔Minimum vertical clearance for a fire lane? - ✔✔13'6"
✔✔Evacuation routes should have - ✔✔A primary and secondary route
✔✔Special amusement buildings should be classified as? - ✔✔Assembly occupancies
✔✔A mixed use occupancy consist of more than one different occupancy under one
roof that? - ✔✔Is not separated by a fire resistance rated occupancy separation
✔✔When two buildings are separated by a fire wall they are considered to be what? -
✔✔Separate buildings
✔✔The minimum Corridor with is determined by - ✔✔The number of people in the type
of occupancy
✔✔The maximum height for doorway threshold - ✔✔Half inch
✔✔Supports for tanks holding more than 500 gallons of dipping and coating flammable
liquids must have a fire rating of at least? - ✔✔A fire rating of one hour
✔✔In a cooking exhaust system the filter will be found in the? - ✔✔Type one hood
✔✔NFPA 495 - ✔✔Explosive Materials Code
✔✔Enclosed processing areas handling or using flammable liquids must be ventilated
at a rate sufficient to maintain the concentration of vapors with in the area at or below
what percentage - ✔✔Below 25%
✔✔The maximum pressure allowed for an atmospheric think storing flammable and
combustible liquids is? - ✔✔.5 psi
✔✔Two ways to increase the threshold quantity for gases or fluids - ✔✔Gas cabinets
and exhausted enclosures
✔✔Two ways to determine the fire load of a building - ✔✔1. Divide the total pounds of
combustible material by the area square footage
2. Use the classification system for fire loads developed by NIST
, ✔✔NFPA 204 - ✔✔Standard for smoke and heat venting
✔✔The standard that provides testing requirements for fire protection systems is what?
- ✔✔UFC 3-601-02
✔✔The type of fire protection system required for most areas with hazardous materials
is a - ✔✔Dry chemical system
✔✔Regardless of the weight of a fire extinguisher, the distance between the bottom of
the extinguisher in the floor should never be less than what distance? - ✔✔Should
never be less than 4 inches
✔✔How often should a 12 year hydrostatic test fire extinguisher be emptied and
subjected to maintenance procedures - ✔✔Every six years
✔✔In a dipping and coating area, the ventilation system must contain vapors to within?
- ✔✔5 feet of the source
✔✔Common hazards associated with HVAC equipment - ✔✔Clogged filters
Improperly adjusted fan belt drives
Combustible lint or debris near burners
✔✔NFPA 1031 - ✔✔Standard for Professional Qualifications for Fire Inspector and Plan
Examiner
✔✔In a sprinkler system, water is distributed directly to branch lines by? - ✔✔Cross
mains
✔✔Who provides contact and logistical information on the plans review application? -
✔✔The applicant for the plans review
✔✔FM-200 - ✔✔Clean agent
✔✔When on-scene to investigate a complaint: - ✔✔1. Bring facility folder
2. take detailed notes
3. ensure correction is initiated before leaving
4. if situation requires work order, ensure the work order is completed.
✔✔NFPA technical committee - ✔✔share information for a recommendation, comment
or proposal for code modification through mail, fax, or electronic format.
