IMSA Signal Technician Level 1 End of
Chapter Exam Newest 2026 Questions and
Correct Detailed Answers Already Graded A+
Which of the follow is an example of adequate fall protection during the
operation of aerial lift equipment? - CORRECT ANSWER-Full body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? -
CORRECT ANSWER-Ensure advance warning devices have not been removed
or relocated
Which of the following is NOT a sentence type in the MUTCD? - CORRECT
ANSWER-Y: Standards; requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good
reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
,Which of the following is an example configuration of an Emergency-Vehicle
Traffic Control Signals: - CORRECT ANSWER-Three-section traffic signal with
circular red, circular yellow, and smaller circular yellow indications
The following phases are typically assigned to the major street through
movements: - CORRECT ANSWER-2 and 6
The green interval is made up which three components? - CORRECT ANSWER-
Minimum green, passage time, maximum green
What are the three types of recall features of a traffic signal controller? -
CORRECT ANSWER-Minimum, maximum, pedestrian (+soft)
In a coordination plan, what is the number of seconds given to each phase at the
intersection? - CORRECT ANSWER-Split (g,y,r)
Which of the following traffic signal coordination method is typically least
expensive? - CORRECT ANSWER-Time-based coordination
, Which of the following is a definition of cycle length: - CORRECT ANSWER-The
elapsed time between the start of a specific display until that display comes up
again
What is the primary function of the IMSA? - CORRECT ANSWER-Safety
education
IMSA stands for: - CORRECT ANSWER-International Municipal Signal
Association
Which of the following is NOT an IMSA certification? - CORRECT ANSWER-Y:
Traffic Signal Level II Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? - CORRECT ANSWER-
Overhead and underground power
Gas
Aerial lift equipment
Chapter Exam Newest 2026 Questions and
Correct Detailed Answers Already Graded A+
Which of the follow is an example of adequate fall protection during the
operation of aerial lift equipment? - CORRECT ANSWER-Full body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? -
CORRECT ANSWER-Ensure advance warning devices have not been removed
or relocated
Which of the following is NOT a sentence type in the MUTCD? - CORRECT
ANSWER-Y: Standards; requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good
reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
,Which of the following is an example configuration of an Emergency-Vehicle
Traffic Control Signals: - CORRECT ANSWER-Three-section traffic signal with
circular red, circular yellow, and smaller circular yellow indications
The following phases are typically assigned to the major street through
movements: - CORRECT ANSWER-2 and 6
The green interval is made up which three components? - CORRECT ANSWER-
Minimum green, passage time, maximum green
What are the three types of recall features of a traffic signal controller? -
CORRECT ANSWER-Minimum, maximum, pedestrian (+soft)
In a coordination plan, what is the number of seconds given to each phase at the
intersection? - CORRECT ANSWER-Split (g,y,r)
Which of the following traffic signal coordination method is typically least
expensive? - CORRECT ANSWER-Time-based coordination
, Which of the following is a definition of cycle length: - CORRECT ANSWER-The
elapsed time between the start of a specific display until that display comes up
again
What is the primary function of the IMSA? - CORRECT ANSWER-Safety
education
IMSA stands for: - CORRECT ANSWER-International Municipal Signal
Association
Which of the following is NOT an IMSA certification? - CORRECT ANSWER-Y:
Traffic Signal Level II Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? - CORRECT ANSWER-
Overhead and underground power
Gas
Aerial lift equipment
