ICC FIRE INSPECTOR 1 TEST PREP EXAM 2
1. 2-1 Asphalt (tar) kettles shall not be located within (BLANK) of any combustible
material, combustible building surface or
any building opening and within a controlled area identified by the use of
traffic cones, barriers or other approved means. Asphalt (tar) kettles and pots
shall not be utilized inside or on the roof of a building or structure. Roofing
kettles and operating asphalt (tar) kettles shall not block means of egress,
gates, roadways or entrances.
Answer C. 20 Feet (IFC 303.2)
2. 2-2 A permit is not required for the installation, alteration or repair of gener-
ation, transmission, distribution or metering or other related equipment that
is under the ownership and control (BLANK).
Answer C. Of public service agencies by established right. (IBC (A) 105.2.2)
3. 2-3 In motor fuel-dispensing facilities, vapor-processing equipment must
1/
22
,be located at or above grade. Sources of ignition may be located not less
than (BLANK) from fuel-transfer areas and not less than 18 inches above tank
fil openings and tops of dispenser islands. Exceptions Ignored.
Answer C. 50 Feet (IFC 2306.7.9.2.2)
4. 2-4 The aggregate floor area of Group H occupancies not located at the
perimeter of the building shall not exceed 25 percent of the area limitations
for the Group H occupancies. Rooms for flammable or combustible liquid use,
dispensing or mixing in open systems having a floor area of more than (BLANK)
need to be located on the outer perimeter of the building where they are in
accordance with the International Fire Code NFPA 30.
Answer C. 500 square Feet (IBC (F) 507.8.1.1)
5. 2-5 In reference to Covered Mall Buildings. Anchor building means of egress.
Required means of egress for anchor buildings must be provided (BLANK)
from the mall means of egress system. The occupant load of anchor buildings
opening into the mall will not be included in determining means of egress
2/
22
, requirements for the mall.
Answer C. Independently (IBC 402.8.4.1)
6. 2-6 In assemblies used for structural fire resistance and fire-resistance-rated
construction, openings other than (BLANK) are not permitted in shaft enclo-
sures.
Answer C. Those necessary for the purpose of the shaft (IBC 713.7.1)
7. 2-7 Exit signs are not required in (BLANK) in occupancies in Group I-3.
Answer A. Sleeping rooms (IBC 1013.1)
3/
22
1. 2-1 Asphalt (tar) kettles shall not be located within (BLANK) of any combustible
material, combustible building surface or
any building opening and within a controlled area identified by the use of
traffic cones, barriers or other approved means. Asphalt (tar) kettles and pots
shall not be utilized inside or on the roof of a building or structure. Roofing
kettles and operating asphalt (tar) kettles shall not block means of egress,
gates, roadways or entrances.
Answer C. 20 Feet (IFC 303.2)
2. 2-2 A permit is not required for the installation, alteration or repair of gener-
ation, transmission, distribution or metering or other related equipment that
is under the ownership and control (BLANK).
Answer C. Of public service agencies by established right. (IBC (A) 105.2.2)
3. 2-3 In motor fuel-dispensing facilities, vapor-processing equipment must
1/
22
,be located at or above grade. Sources of ignition may be located not less
than (BLANK) from fuel-transfer areas and not less than 18 inches above tank
fil openings and tops of dispenser islands. Exceptions Ignored.
Answer C. 50 Feet (IFC 2306.7.9.2.2)
4. 2-4 The aggregate floor area of Group H occupancies not located at the
perimeter of the building shall not exceed 25 percent of the area limitations
for the Group H occupancies. Rooms for flammable or combustible liquid use,
dispensing or mixing in open systems having a floor area of more than (BLANK)
need to be located on the outer perimeter of the building where they are in
accordance with the International Fire Code NFPA 30.
Answer C. 500 square Feet (IBC (F) 507.8.1.1)
5. 2-5 In reference to Covered Mall Buildings. Anchor building means of egress.
Required means of egress for anchor buildings must be provided (BLANK)
from the mall means of egress system. The occupant load of anchor buildings
opening into the mall will not be included in determining means of egress
2/
22
, requirements for the mall.
Answer C. Independently (IBC 402.8.4.1)
6. 2-6 In assemblies used for structural fire resistance and fire-resistance-rated
construction, openings other than (BLANK) are not permitted in shaft enclo-
sures.
Answer C. Those necessary for the purpose of the shaft (IBC 713.7.1)
7. 2-7 Exit signs are not required in (BLANK) in occupancies in Group I-3.
Answer A. Sleeping rooms (IBC 1013.1)
3/
22
