2025 AQA A-LEVEL DESIGN AND TECHNOLOGY: PRODUCT DESIGN Paper 2
Designing and Making Principles
Question Paper & Mark Scheme (Merged) Tuesday 10 June 2025 [VERIFIED]
, 2
Do not write
outside the
Section A – Product Analysis box
Answer all questions in this section.
0 1 Figures 1 and 2 show two pens.
Figure 1 Disposable Figure 2
polymer pen Refillable stainless steel pen
Figure 1 Figure 2
Material(s) used Thermoplastics Stainless Steel
Manufacturing processes used Polymer deformation Metal deformation
Compare and evaluate the two pens shown.
In your answer you should refer to material and design suitability for large-scale
production.
[12 marks]
G/Jun25/7552/2
, 3
Do not write
outside the
box
12
Turn over for the next question
G/Jun25/7552/2
, 4
Do not write
outside the
box
Turn over U
G/Jun25/7552/2
Designing and Making Principles
Question Paper & Mark Scheme (Merged) Tuesday 10 June 2025 [VERIFIED]
, 2
Do not write
outside the
Section A – Product Analysis box
Answer all questions in this section.
0 1 Figures 1 and 2 show two pens.
Figure 1 Disposable Figure 2
polymer pen Refillable stainless steel pen
Figure 1 Figure 2
Material(s) used Thermoplastics Stainless Steel
Manufacturing processes used Polymer deformation Metal deformation
Compare and evaluate the two pens shown.
In your answer you should refer to material and design suitability for large-scale
production.
[12 marks]
G/Jun25/7552/2
, 3
Do not write
outside the
box
12
Turn over for the next question
G/Jun25/7552/2
, 4
Do not write
outside the
box
Turn over U
G/Jun25/7552/2
