1
FDOT Asphalt Paving Level 1 Questions
and Answers (100% Correct Answers)
Already Graded A+
S to N Ans: Downstation
© 2025 Assignment Expert
W to E Ans: Downstation
Stationing Ans: Starts at 0+00
Guru01 - Stuvia
Stationing Measurement Ans: 1+00 is 100 feet
Straight Edge is the Ans: Measurement of Pavement smoothness
with a 15 foot 4.573 m rolling straightedge
Straight Edge is used to Ans: identify problems
Random sampling Ans: Are random numbers generated usually
by a VT for cores to be extracted from the roadway
How often should you calibrate a Straight edge Ans: Calibrate at
the start of each working period
Using the manual straight edge you find what kind of spot to
place the rolling straightedge? Ans: Locate a flat area with the
, 2
manual straightedge and place the rolling straightedge next to
the manual straightedge and the gauge should read 0
The 3/16 and the 3/8 shims go under which wheels during
calibration Ans: The outside wheels to measure the low and the
center to measure the high. Gauge should read 3/16 on the 3/16
shim and vice versa for the 3/8 shims. Make sure the center wheel
moves up and down freely.
© 2025 Assignment Expert
Calibration materials for Straightedge Ans: Rolling Straightedge
Manual Straightedge
Guru01 - Stuvia
Manual Measurement (ruler)
x4 3/16 shims 5mm thick
x4 3/8 shims 10mm thick
When to perform final straightedge Ans: After an entire lane has
been paved
When to perform final straightedge Ans: Pavement should be an
ambient temperature
You cannot use the straightedge until it has been properly Ans:
calibrated
FDOT Asphalt Paving Level 1 Questions
and Answers (100% Correct Answers)
Already Graded A+
S to N Ans: Downstation
© 2025 Assignment Expert
W to E Ans: Downstation
Stationing Ans: Starts at 0+00
Guru01 - Stuvia
Stationing Measurement Ans: 1+00 is 100 feet
Straight Edge is the Ans: Measurement of Pavement smoothness
with a 15 foot 4.573 m rolling straightedge
Straight Edge is used to Ans: identify problems
Random sampling Ans: Are random numbers generated usually
by a VT for cores to be extracted from the roadway
How often should you calibrate a Straight edge Ans: Calibrate at
the start of each working period
Using the manual straight edge you find what kind of spot to
place the rolling straightedge? Ans: Locate a flat area with the
, 2
manual straightedge and place the rolling straightedge next to
the manual straightedge and the gauge should read 0
The 3/16 and the 3/8 shims go under which wheels during
calibration Ans: The outside wheels to measure the low and the
center to measure the high. Gauge should read 3/16 on the 3/16
shim and vice versa for the 3/8 shims. Make sure the center wheel
moves up and down freely.
© 2025 Assignment Expert
Calibration materials for Straightedge Ans: Rolling Straightedge
Manual Straightedge
Guru01 - Stuvia
Manual Measurement (ruler)
x4 3/16 shims 5mm thick
x4 3/8 shims 10mm thick
When to perform final straightedge Ans: After an entire lane has
been paved
When to perform final straightedge Ans: Pavement should be an
ambient temperature
You cannot use the straightedge until it has been properly Ans:
calibrated
