Terms in this set (108)
reinforcement
Adding a pipe branch connection by
welding is allowed providing
__________ is performed.
ASME
All safety relief valves installed on
pressure equipment in OR must be
_________ approved
Amount of weld reinforcement is Thickness
determined by _________.
thickness
Amount of weld reinforcement is
determined by ________ of the metal.
Section 1
ASME code governing power boilers?
ASME code that regulates controls in CSD-1
automatically fired boilers?
45
An assembled boiler shall be subjected to
a hydrostatic test of not less than
_________ psig.
Furnace welded
ASTM A-58-F pipe. What does the F
mean?
company confined space procedures are followed.
Before entering a boiler or pressure
vessel:
, 80
Blowoff piping from a boiler when the
pressure exceeds 100 psig needs to be at
least what schedule?
A blueprint solid line with an arrow is a Dimension line
_______ ________.
Blueprint solid line with arrows is a Dimension
_________ line
150
Building Service Steam Piping operates at
a pressure no less than _______
no
Can a safety valve be installed below the
lowest permissible water level?
yes
Can you swap a valve like for like and
need a permit?
45 psi
A cast iron steam boiler after being
installed be must tested at:
A class VI welder needs to be supervised IV or V
by a class _____ or _____?
keep water temp. below 210 and relieve at the set pressure of the safety valve.
Combination temperature and pressure
relief valves are used on direct fired hot
water supply boilers in order to:
reinforcement
Adding a pipe branch connection by
welding is allowed providing
__________ is performed.
ASME
All safety relief valves installed on
pressure equipment in OR must be
_________ approved
Amount of weld reinforcement is Thickness
determined by _________.
thickness
Amount of weld reinforcement is
determined by ________ of the metal.
Section 1
ASME code governing power boilers?
ASME code that regulates controls in CSD-1
automatically fired boilers?
45
An assembled boiler shall be subjected to
a hydrostatic test of not less than
_________ psig.
Furnace welded
ASTM A-58-F pipe. What does the F
mean?
company confined space procedures are followed.
Before entering a boiler or pressure
vessel:
, 80
Blowoff piping from a boiler when the
pressure exceeds 100 psig needs to be at
least what schedule?
A blueprint solid line with an arrow is a Dimension line
_______ ________.
Blueprint solid line with arrows is a Dimension
_________ line
150
Building Service Steam Piping operates at
a pressure no less than _______
no
Can a safety valve be installed below the
lowest permissible water level?
yes
Can you swap a valve like for like and
need a permit?
45 psi
A cast iron steam boiler after being
installed be must tested at:
A class VI welder needs to be supervised IV or V
by a class _____ or _____?
keep water temp. below 210 and relieve at the set pressure of the safety valve.
Combination temperature and pressure
relief valves are used on direct fired hot
water supply boilers in order to:
