Telecom Tower Technician 1 Exam Questions & Answers Latest Update 100% Solved
Telecom Tower Technician 1 Exam Questions &
Answers Latest Update 100% Solved
The basket slings on a gin pole perform what function? - ✔-Support part of the weight and vertical
forces
What is the minimum force that a work positioning system anchorage must be able to withstand? - ✔-
2 times the arresting force or 3,000 lbs
What term identifies a monopole component? - ✔-Base flange
All antennas are presumed active - ✔-True
When using bolts or u-bolts with a slotted hole present, what order are the components installed? - ✔-
Flat washer, lock washer, then nut
If you have a 16 ft ladder leaning against a building wall, how many feet from the wall does the base
need to be to provide the correct slope? - ✔-4 ft
For structural loading purposes the basket and bridle slings shall always be attached where? - ✔-At a
panel point around the leg
A hoist operator will respond to a stop signal from whom? - ✔-Any source
When calculating a fall distance using a 6 foot energy absorber, what is the maximum pull out distance?
- ✔-4 feet
How often shall all gin poles have a documented job inspection? - ✔-Daily
What do the letters LOTO stand for? - ✔-Lockout Tagout
Telecom Tower Technician 1 Exam Questions & Answers Latest Update 100% Solved
, Telecom Tower Technician 1 Exam Questions & Answers Latest Update 100% Solved
What does a tag person do? - ✔-Applied pressure on the tag rope to controls the load
A capstan hoist is used on job sites for what purpose? - ✔-To raise and lower loads
When operating a Capstan Hoist, or tagging the load on the Capstan, it is important to wear what? - ✔-
Gloves
What does a Ground Fault Circuit Interrupter (GFCI) do? - ✔-Shuts off flow of electricity, senses a short
circuit, and prevents electricution
Which of the following is not a component of the gross load? - ✔-Tag force
What motion indicates retract the boom - ✔-Both fists in front of your body with your thumbs pointed
towards each other
What is the heel block used for? - ✔-To change the direction of the load, jump or tag line from
horizontal to vertical
An overhaul ball provides what function in the operations? - ✔-Provides weight allowing the load line
to treturn the ground
If the operator and signal person cannot see each other, what other way can they communicate? - ✔-
Radios
The three main components that make up a fall arrest system are - ✔-Anchorage, Full body Harness,
and connectors
What type of antenna is used to transmit signal from tower to tower? - ✔-Microwave dish
For all power lines rated 50kv, the minimum clearance between the lines and any part of the crane or
load shall be - ✔-20 feet
Telecom Tower Technician 1 Exam Questions & Answers Latest Update 100% Solved
Telecom Tower Technician 1 Exam Questions &
Answers Latest Update 100% Solved
The basket slings on a gin pole perform what function? - ✔-Support part of the weight and vertical
forces
What is the minimum force that a work positioning system anchorage must be able to withstand? - ✔-
2 times the arresting force or 3,000 lbs
What term identifies a monopole component? - ✔-Base flange
All antennas are presumed active - ✔-True
When using bolts or u-bolts with a slotted hole present, what order are the components installed? - ✔-
Flat washer, lock washer, then nut
If you have a 16 ft ladder leaning against a building wall, how many feet from the wall does the base
need to be to provide the correct slope? - ✔-4 ft
For structural loading purposes the basket and bridle slings shall always be attached where? - ✔-At a
panel point around the leg
A hoist operator will respond to a stop signal from whom? - ✔-Any source
When calculating a fall distance using a 6 foot energy absorber, what is the maximum pull out distance?
- ✔-4 feet
How often shall all gin poles have a documented job inspection? - ✔-Daily
What do the letters LOTO stand for? - ✔-Lockout Tagout
Telecom Tower Technician 1 Exam Questions & Answers Latest Update 100% Solved
, Telecom Tower Technician 1 Exam Questions & Answers Latest Update 100% Solved
What does a tag person do? - ✔-Applied pressure on the tag rope to controls the load
A capstan hoist is used on job sites for what purpose? - ✔-To raise and lower loads
When operating a Capstan Hoist, or tagging the load on the Capstan, it is important to wear what? - ✔-
Gloves
What does a Ground Fault Circuit Interrupter (GFCI) do? - ✔-Shuts off flow of electricity, senses a short
circuit, and prevents electricution
Which of the following is not a component of the gross load? - ✔-Tag force
What motion indicates retract the boom - ✔-Both fists in front of your body with your thumbs pointed
towards each other
What is the heel block used for? - ✔-To change the direction of the load, jump or tag line from
horizontal to vertical
An overhaul ball provides what function in the operations? - ✔-Provides weight allowing the load line
to treturn the ground
If the operator and signal person cannot see each other, what other way can they communicate? - ✔-
Radios
The three main components that make up a fall arrest system are - ✔-Anchorage, Full body Harness,
and connectors
What type of antenna is used to transmit signal from tower to tower? - ✔-Microwave dish
For all power lines rated 50kv, the minimum clearance between the lines and any part of the crane or
load shall be - ✔-20 feet
Telecom Tower Technician 1 Exam Questions & Answers Latest Update 100% Solved
