RVTI LEVEL 1 UPDATED EXAM QUESTIONS AND ANSWERS
RATED A+
✔✔A technician is testing a motorized RV. The first step enacted is ensuring that the
seat moves up, down, forward, and back. Identify the next main steps for the technician
to perform. - ✔✔Adjust seatback, rest seat heaters, inspect armrest
✔✔When performing a propylene glycol level test, you should use which tool -
✔✔Refractometer
✔✔The engine must run for a few minutes for this to work properly. - ✔✔Heat and cool
modes
✔✔When performing a propylene glycol concentration level test, if the percentage is too
high, you should add - ✔✔Deionized water
✔✔When performing PDI on chassis dash components, check rear and side view -
✔✔Mirrors
✔✔When inspecting roof and ducted air conditioners - ✔✔Test fan speed and operate
vents
✔✔When performing PDI on chassis dash components, check - ✔✔Backup monitor
✔✔What ultimately determines if the air conditioner is functioning properly? - ✔✔Delta
temperature
✔✔As a typical part of PDI, a technician needs to ensure headlights function when -
✔✔Dim and bright
✔✔During the 12-24 hour run test, on an RV fridge, what should the thermometer read?
- ✔✔40 to 43°F
✔✔Which is a convenience light? - ✔✔Fog light
✔✔Two types of furnaces used in RVs are - ✔✔Forced air and hydronic
✔✔What should be warm to be properly checked? - ✔✔Power steering fluid
✔✔When conducting PDI on RV furnaces, set the thermostat to what setting? -
✔✔Highest
, ✔✔When inspecting the hydraulic fluid level in the reservoir, clean the top of the
Reservoir before removing the cap to - ✔✔Prevent foreign material from entering the
hydraulic system
✔✔When conducing PDI on RV furnaces, ensure that air flow is - ✔✔Warmer than
ambient temperature
✔✔For chassis leveling systems, hydraulic fluid should always be checked when
levelers and/or rooms are - ✔✔Retracted
✔✔Water heaters can be tested only after the water tanks have been - ✔✔Filled
✔✔When interpreting the year of production, an RV tire has a typical life of - ✔✔5 to 7
years
✔✔When inspecting ovens, set the oven thermostat to - ✔✔300°F
✔✔When verifying the age of a tire, "1206" in the last grouping indicates the tire was
made in the - ✔✔12th week of 2006
✔✔When performing PDI on a microwave, set a _____ in the appliance - ✔✔Container
of water
✔✔When inspecting tires on a towable RV, inspect lug nuts for proper - ✔✔Torque
✔✔RV generators can be powered by - ✔✔Gasoline and propane
✔✔When verifying the installation of pin box couplers on a fifth wheel hitch, the hitch
should be ______ the frame. - ✔✔Square with
✔✔A generator transforms _____ energy into _____ energy. - ✔✔Mechanical; electrical
✔✔Inspect the whole underside of the towable coach looking for loose, hanging, or
_______ components. - ✔✔Damaged
✔✔Prior to putting a load online, allow a warm-up period of ______ to _____ minutes. -
✔✔2; 5
✔✔Before using stabilizer jacks, be sure that the landing gear on the _____ wheel
operates properly. - ✔✔Fifth
✔✔Current generators have non-adjustable carburetors that are - ✔✔EPA-mandated
RATED A+
✔✔A technician is testing a motorized RV. The first step enacted is ensuring that the
seat moves up, down, forward, and back. Identify the next main steps for the technician
to perform. - ✔✔Adjust seatback, rest seat heaters, inspect armrest
✔✔When performing a propylene glycol level test, you should use which tool -
✔✔Refractometer
✔✔The engine must run for a few minutes for this to work properly. - ✔✔Heat and cool
modes
✔✔When performing a propylene glycol concentration level test, if the percentage is too
high, you should add - ✔✔Deionized water
✔✔When performing PDI on chassis dash components, check rear and side view -
✔✔Mirrors
✔✔When inspecting roof and ducted air conditioners - ✔✔Test fan speed and operate
vents
✔✔When performing PDI on chassis dash components, check - ✔✔Backup monitor
✔✔What ultimately determines if the air conditioner is functioning properly? - ✔✔Delta
temperature
✔✔As a typical part of PDI, a technician needs to ensure headlights function when -
✔✔Dim and bright
✔✔During the 12-24 hour run test, on an RV fridge, what should the thermometer read?
- ✔✔40 to 43°F
✔✔Which is a convenience light? - ✔✔Fog light
✔✔Two types of furnaces used in RVs are - ✔✔Forced air and hydronic
✔✔What should be warm to be properly checked? - ✔✔Power steering fluid
✔✔When conducting PDI on RV furnaces, set the thermostat to what setting? -
✔✔Highest
, ✔✔When inspecting the hydraulic fluid level in the reservoir, clean the top of the
Reservoir before removing the cap to - ✔✔Prevent foreign material from entering the
hydraulic system
✔✔When conducing PDI on RV furnaces, ensure that air flow is - ✔✔Warmer than
ambient temperature
✔✔For chassis leveling systems, hydraulic fluid should always be checked when
levelers and/or rooms are - ✔✔Retracted
✔✔Water heaters can be tested only after the water tanks have been - ✔✔Filled
✔✔When interpreting the year of production, an RV tire has a typical life of - ✔✔5 to 7
years
✔✔When inspecting ovens, set the oven thermostat to - ✔✔300°F
✔✔When verifying the age of a tire, "1206" in the last grouping indicates the tire was
made in the - ✔✔12th week of 2006
✔✔When performing PDI on a microwave, set a _____ in the appliance - ✔✔Container
of water
✔✔When inspecting tires on a towable RV, inspect lug nuts for proper - ✔✔Torque
✔✔RV generators can be powered by - ✔✔Gasoline and propane
✔✔When verifying the installation of pin box couplers on a fifth wheel hitch, the hitch
should be ______ the frame. - ✔✔Square with
✔✔A generator transforms _____ energy into _____ energy. - ✔✔Mechanical; electrical
✔✔Inspect the whole underside of the towable coach looking for loose, hanging, or
_______ components. - ✔✔Damaged
✔✔Prior to putting a load online, allow a warm-up period of ______ to _____ minutes. -
✔✔2; 5
✔✔Before using stabilizer jacks, be sure that the landing gear on the _____ wheel
operates properly. - ✔✔Fifth
✔✔Current generators have non-adjustable carburetors that are - ✔✔EPA-mandated
