Jatc Test 2 Job info level 1 Questions
Wit Outlined Answers
\.___ or socket wrench are safest to remove frozen fasteners - Answer- Box
\.Excessive ___ causes wrenches to weaken - Answer- heating
\.Never____ on a screwdriver - Answer- Hammer
\.Use a ____ wrench to avoid marring a pipe - Answer- Strap
\.slip joint pliers are sometimes referred to as ____ and groove pliers. - Answer- tongue
\.The 3 parts of the screw driver consist of the handle , blade and____? - Answer- shank
\.linemen's side cutting pliers have two main styles. One being square nose and the other? -
Answer- New England nose
\.Safe practices in the job site include? - Answer- 1)Removing jewelry and rings.
2)Removing fasteners / staples from packing boxes before removing contents
3)Stack waste materials so weight is evenly distributed
4)Cleaning up after each small job is finished
\.Trash accumulation on the jobsite: - Answer- 1) conceals dangers underneath
, 2) Creates a fire hazard
3)makes falls likely '
4)Does not indicate a productive work day.
\.A neat jobsite can be an asset for you, the contractor , the customer and lead to _____? -
Answer- Future work
\.Causes of accidents on a job are unsafe conditions and ____? - Answer- Unsafe acts
\.Apprentices are in charge of clean-up because they are cheap and lack ___? - Answer-
experience
\.___are responsible for job safety. - Answer- You
\.Ladders not in use should be laid down or ___. - Answer- Lashed
\.Always keep both hands ___ when ascending and descending ladders. - Answer- Free
\.Leaning a step ladder against the wall to use is ____. - Answer- Unsafe
\.Max length for a fully extended ladder is __? - Answer- 55ft
\.Extension ladders should have at least ___ over lap between section when extended. -
Answer- 3ft
\.Single ladders longer than ___ feet should not be used. - Answer- 30ft
Wit Outlined Answers
\.___ or socket wrench are safest to remove frozen fasteners - Answer- Box
\.Excessive ___ causes wrenches to weaken - Answer- heating
\.Never____ on a screwdriver - Answer- Hammer
\.Use a ____ wrench to avoid marring a pipe - Answer- Strap
\.slip joint pliers are sometimes referred to as ____ and groove pliers. - Answer- tongue
\.The 3 parts of the screw driver consist of the handle , blade and____? - Answer- shank
\.linemen's side cutting pliers have two main styles. One being square nose and the other? -
Answer- New England nose
\.Safe practices in the job site include? - Answer- 1)Removing jewelry and rings.
2)Removing fasteners / staples from packing boxes before removing contents
3)Stack waste materials so weight is evenly distributed
4)Cleaning up after each small job is finished
\.Trash accumulation on the jobsite: - Answer- 1) conceals dangers underneath
, 2) Creates a fire hazard
3)makes falls likely '
4)Does not indicate a productive work day.
\.A neat jobsite can be an asset for you, the contractor , the customer and lead to _____? -
Answer- Future work
\.Causes of accidents on a job are unsafe conditions and ____? - Answer- Unsafe acts
\.Apprentices are in charge of clean-up because they are cheap and lack ___? - Answer-
experience
\.___are responsible for job safety. - Answer- You
\.Ladders not in use should be laid down or ___. - Answer- Lashed
\.Always keep both hands ___ when ascending and descending ladders. - Answer- Free
\.Leaning a step ladder against the wall to use is ____. - Answer- Unsafe
\.Max length for a fully extended ladder is __? - Answer- 55ft
\.Extension ladders should have at least ___ over lap between section when extended. -
Answer- 3ft
\.Single ladders longer than ___ feet should not be used. - Answer- 30ft
