• Wrong document? Swap it for free
  • Written by students who passed
  • Immediately available after payment
  • Read online or as PDF
Sell
Where do you study
Your language
Document preview thumbnail
Preview 2 out of 6 pages
Exam (elaborations)

HVAC Electrical Test with All Correct & 100% Verified Answers |Latest Version| Already Graded A+

Document preview thumbnail
Preview 2 out of 6 pages

HVAC Electrical Test with All Correct & 100% Verified Answers |Latest Version| Already Graded A+

Content preview

HVAC Electrical Test with All Correct & 100% Verified
Answers |Latest Version| Already Graded A+

Current flow is ✔Correct Answer-the flow of electrons in the circuit

impedance is ✔Correct Answer-opposition to alternating current flow

like charges ✔Correct Answer-repel each other

Any material that will readily release electrons is called ✔Correct Answer-a conductor

the symbol for current is ✔Correct Answer-I

Which of the following materials would best be suited for use as a semi-conductor ✔Correct
Answer-silicone

the safety ground conductor is usually color coded ✔Correct Answer-black (or bare or green &
yellow stripe)

An electron has ✔Correct Answer-a negative charge

resistance is ✔Correct Answer-opposition to current flow

How many watts of power are used by a heater operating at 460 volts and drawing 5 amps?
✔Correct Answer-2300 watts

What type of meter uses its own battery? ✔Correct Answer-ohmmeter

in electrical wiring a black colored wire usually indicates ✔Correct Answer-the hot conductor

Fuses are sized by ✔Correct Answer-Volts & Amps

Two 120 volt incandescent light bulbs are wired in series, one is a 60 watt bulb, the other is a 4 watt
bulb. The result would be; ✔Correct Answer-Both bulbs light

Three defrost heaters; each 15 ohms are wired in parallel to a 120 volt power supply. How many
watts of power will be used? ✔Correct Answer-2880 watts

What is generally considered to be the maximum allowable (plus or minus) supply voltage variation?
✔Correct Answer-5%

Capacitors are rated in: ✔Correct Answer-Microfarads & Volts

When testing a capacitor with an analog ohmmeter, the needle on the meter should; ✔Correct
Answer-deflect towards zero then return to infinite reading.

What is the term used to describe the output side of a transformer? ✔Correct Answer-Secondary
side

, One horsepower is equal to how many watts? ✔Correct Answer-746 Watts

How much resistance must be placed in a 120 volt circuit in order to limit the current to 2 amps?
✔Correct Answer-60 ohms

A parallel circuit contains a 18 ohm and 9 ohm resistor. The total resistance equals; ✔Correct
Answer-6 ohms

In a series circuit, the voltage drop across each resistance (load) will; ✔Correct Answer-Add up to
equal the source voltage

The total resistance of a parallel circuit will be; ✔Correct Answer-Less than the smallest resistance

Which of the following statements about current is true? ✔Correct Answer-Current flow will
increase when voltage increases.

When resistors are wired in parallel; ✔Correct Answer-The voltage drop across each resistor will be
the same as the applied source voltage.

Which of the following is equal to 2.1KW? ✔Correct Answer-2,100 Watts

Which of the following is equal to 100 milliamps? ✔Correct Answer-0.10 amperes

A capacitor analyzer is designed to read; ✔Correct Answer-the capacitance of a capacitor

A 240 volt, 3 wire circuit can be split into two 120 volt circuits. ✔Correct Answer-TRUE

The electric meter on a house measures the _______ passing through it. ✔Correct Answer-wattage

A three phase load requires a minimum of; ✔Correct Answer-three supply lines

Which of the following is the correct formula for determining wattage in an electrical circuit?
✔Correct Answer-W = E times I (or V x I)

A parallel circuit consists of three resistors
R1=30 ohms R2=15 ohms R3=10ohms
if the current through R2=4 amperes, what is the source voltage? ✔Correct Answer-60 volts

The 300 ohm resistors are wired in parallel. The total resistance equals; ✔Correct Answer-100
ohms

An electronically commutated motor (ECM) is Designed to ✔Correct Answer-provide proper air
flow under various conditions.

Resistance can be calculated by ✔Correct Answer-E divided by I (R = E/I)

Voltage can be calculated by ✔Correct Answer-I times R

An ohmmeter should never be connected to ✔Correct Answer-a live circuit

Which of the following would be considered an inductive load? ✔Correct Answer-electric motor

Document information

Uploaded on
October 27, 2025
Number of pages
6
Written in
2025/2026
Type
Exam (elaborations)
Contains
Questions & answers
$12.99

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
Studyclub
3.6
(14)
Sold
70
Followers
1
Items
13416
Last sold
3 days ago



Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions