Questions with Answers (100% Correct Answers)
On a typical diesel subsystem, what system would most likely be used at the lowest pressure
when the engine is running? —Answer: Primary filter
Where is the secondary fuel filter usually located? —Answer: on the side of the transfer pump
Besides fue4l storage, the fuel tank may play an important role in a high-flow fuel system as a:
—Answer: Heat exchanger
What could be used to test the low-pressure side of a typical diesel fuel subsystem for inlet
restriction? —Answer: Negative pressure gauge
Which of the following should fuel subsystem charging pressures be measured with?
a.) Diagnostic sight glass
b.) H20 manometer
c.) HG manometer
d.) Accurate pressure gauge —Answer: D
What type of fuel transfer pump is more commonly used by electronically managed engine/fuel
systems? —Answer: Gear pumps
What type of pumping principle is used by a typical hand primer pump? —Answer: Single
acting plunger
Charging pressure rise is usually directly related to what? —Answer: Increased RPM
What is the purpose of the air inlet system? —Answer: To provide clean air to engine and
optimize air flow
© 2025 All rights reserved