BICSI TECHNICIAN FINAL PAPER 2026
COMPLETE EXAM QUESTIONS AND
SOLUTIONS 100% CORRECT
● To avoid damaging cable jacket, how often must you securely fasten
electrical nonmetallic tubing (ENT) Answer: 3 Feet so it does not
damage the cable
● What is the minimum dedicated power requirement of a
telecommunications enclosure Answer: 120 V ac/20
● The clearance behind the PBB when mounted, should be no less than-
Answer: 2inch clearance behind the PBB when mounted
● When installing a plywood backboard, you should use galvanized
screws that are a minimum of ______ longer than the depth of the wall
covering, including the plywood Answer: 0.5in
● The use of under carpet telecommunications cable should be limited
to: Answer: The interconnection point between horizontal cabling and
UTC is a transition point (TP)
, ● Two 90-degree bends are allowed in any one conduit segment. A third
bend may be acceptable under certain situations Answer: Runs under 33
feet
● When installing racks and cabinets on an access floor, what should
they be secured to? Answer: The frame
● When placing cabinets on an access floor, how should the cabinets be
aligned? Answer: One edge flush with the floor tile cut line
● What is a telecommunications enclosure TE used for? Answer: May
be used to provide a suitable option for moves, adds, and changes
without compromising infection control measures and other restrictions
● What size threaded rod would you typically use in a heavy duty ladder
rack installation? Answer: 5/8in
● A supplemental bonding network within an ER or data center
consisting of a set of conductors formed into a grid is often associated
with what? Answer: Access flooring
● Which type of anchor requires a hole to be drilled into the floor where
the attachment is to be made? Answer: Expansion anchors
● Min seperation from electric motors and transformers? Answer: 48"
COMPLETE EXAM QUESTIONS AND
SOLUTIONS 100% CORRECT
● To avoid damaging cable jacket, how often must you securely fasten
electrical nonmetallic tubing (ENT) Answer: 3 Feet so it does not
damage the cable
● What is the minimum dedicated power requirement of a
telecommunications enclosure Answer: 120 V ac/20
● The clearance behind the PBB when mounted, should be no less than-
Answer: 2inch clearance behind the PBB when mounted
● When installing a plywood backboard, you should use galvanized
screws that are a minimum of ______ longer than the depth of the wall
covering, including the plywood Answer: 0.5in
● The use of under carpet telecommunications cable should be limited
to: Answer: The interconnection point between horizontal cabling and
UTC is a transition point (TP)
, ● Two 90-degree bends are allowed in any one conduit segment. A third
bend may be acceptable under certain situations Answer: Runs under 33
feet
● When installing racks and cabinets on an access floor, what should
they be secured to? Answer: The frame
● When placing cabinets on an access floor, how should the cabinets be
aligned? Answer: One edge flush with the floor tile cut line
● What is a telecommunications enclosure TE used for? Answer: May
be used to provide a suitable option for moves, adds, and changes
without compromising infection control measures and other restrictions
● What size threaded rod would you typically use in a heavy duty ladder
rack installation? Answer: 5/8in
● A supplemental bonding network within an ER or data center
consisting of a set of conductors formed into a grid is often associated
with what? Answer: Access flooring
● Which type of anchor requires a hole to be drilled into the floor where
the attachment is to be made? Answer: Expansion anchors
● Min seperation from electric motors and transformers? Answer: 48"
