VIRGINIA HEAVY LATEST
HIGHWAY BATCH 1
What size berm is needed on a tank pad - ANSWERS-5 foot
What is the maximum punitive damages assessed for excavating without
having the utilities marked? - ANSWERS-$10,000
Asphault should be rolled? - ANSWERS-On the hot side with a small
overlap on the cold side
A tank should have a relief valve located where? - ANSWERS-At the
top
All tanks shall be outfitted with - ANSWERS-Pressure relief valves (or
safety valve)
A tank inlet and outlet shall be - ANSWERS-the same size +/-
Recaimed asphault containing more than 0.1% tar is considered -
ANSWERS-Hazordous waste
END OF
PAGE 1
, VIRGINIA HEAVY LATEST
HIGHWAY BATCH 1
What would be the worst choice to roll hot asphault - ANSWERS-
Rubber wheel
The two tow points on both sides of an asphault paver MUST -
ANSWERS-be level above the ground
For runways, what MUST be done to side forms each time they are
used? - ANSWERS-Must be cleaned and oiled
When a low pressure tank is in normal operation, what pressure can it
not exceed - ANSWERS-Design pressure
What report can be inititally used to assess pile driving, and the best type
of pile length/type to use - ANSWERS-Geotechnical report
With a low pressure tank, what is the MAXIMUM dimension out of
round that is permitted? - ANSWERS-12 inches
When constructing a excavation protection system, what MUST be
onsite and available? - ANSWERS-The manufactures data
END OF
PAGE 2
HIGHWAY BATCH 1
What size berm is needed on a tank pad - ANSWERS-5 foot
What is the maximum punitive damages assessed for excavating without
having the utilities marked? - ANSWERS-$10,000
Asphault should be rolled? - ANSWERS-On the hot side with a small
overlap on the cold side
A tank should have a relief valve located where? - ANSWERS-At the
top
All tanks shall be outfitted with - ANSWERS-Pressure relief valves (or
safety valve)
A tank inlet and outlet shall be - ANSWERS-the same size +/-
Recaimed asphault containing more than 0.1% tar is considered -
ANSWERS-Hazordous waste
END OF
PAGE 1
, VIRGINIA HEAVY LATEST
HIGHWAY BATCH 1
What would be the worst choice to roll hot asphault - ANSWERS-
Rubber wheel
The two tow points on both sides of an asphault paver MUST -
ANSWERS-be level above the ground
For runways, what MUST be done to side forms each time they are
used? - ANSWERS-Must be cleaned and oiled
When a low pressure tank is in normal operation, what pressure can it
not exceed - ANSWERS-Design pressure
What report can be inititally used to assess pile driving, and the best type
of pile length/type to use - ANSWERS-Geotechnical report
With a low pressure tank, what is the MAXIMUM dimension out of
round that is permitted? - ANSWERS-12 inches
When constructing a excavation protection system, what MUST be
onsite and available? - ANSWERS-The manufactures data
END OF
PAGE 2
